Bush hog Q

   / Bush hog Q #1  

repete

Veteran Member
Joined
May 26, 2008
Messages
1,175
Location
SW Washington
Tractor
L2550DT IH584-4WD
I have an old 5' brush hog I use for mowing rough stuff. I do not know the maker.
My question is are the blades and bolts generic for these machines. My blades measure 24"
 
   / Bush hog Q #2  
The blades are pretty interchangeable between cutters in lots of cases.

I would take the old blades off, and then physically compare them to the new ones, if possible.

You have to check the length, width, and the bolt hole, and make sure they are precisely the same. Some blades are high lift type, and some aren't, meaning the cutting edge reverse side is raised to lift the clippings.
 
   / Bush hog Q #3  
I have an old 5' brush hog I use for mowing rough stuff. I do not know the maker.
My question is are the blades and bolts generic for these machines. My blades measure 24"
Can you post a photo? Most folks here seem pretty good at picking out a model even if it's rough looking.
 

Tractor & Equipment Auctions

2011 Cadillac SRX LUXURY (A50324)
2011 Cadillac SRX...
2018 FONTAINE TRAILER CO. 55 TON RGN 3-AXLE DETACH W/4TH AXLE JEEP (A50854)
2018 FONTAINE...
2006 INTERNATIONAL 7600 T/A DUMP TRUCK (A51406)
2006 INTERNATIONAL...
2019 FORD F550 XL SERVICE TRUCK (A51243)
2019 FORD F550 XL...
John Deere Quick Attach Bale Spear (A50514)
John Deere Quick...
Morooka MST 660VD Tracked Dump Truck  Only 30 Hours (A51039)
Morooka MST 660VD...
 
Top