Bucket level indicator
- Thread starter Modrob
- Start date
- Views: 394
Make one. Strap or weld a tube on the loader cylinder mount where you can see it. The run a rod thru it down to the bucket cylinder mount and pin it there. (Not the bucket because if you swap it out....) Set the bucket to a zero position of your choice and put a piece of electrical tape on the rod as it enters the tube. After a while you'll get used to it and recognize the level position just from the cylinder length.
Don't laugh, but I've also seen someone putting a camera up there. GPS is not accurate enough ( Theoretically), but I'm sure there's a propeller head out there willing to try it.).
Don't laugh, but I've also seen someone putting a camera up there. GPS is not accurate enough ( Theoretically), but I'm sure there's a propeller head out there willing to try it.).
m5040
Veteran Member
- Joined
- Nov 23, 2008
- Messages
- 1,031
- Location
- CT
- Tractor
- Kubota M6040 L2250, JohnDeere 310D, Ford 841 Elenco, Ford 961, Trapmaster, PT180 w/LM bucket and 45" brush cutter, PT1430 Deutz w/grapple bucket, Antonio Carraro Tigrecar 6500. John Deere 5300. Former owned Steiner 430 max, Goldoni REV Maxter 7
Simple, like Kubota. Weld a piece of "L" shaped metal (an upside down L), with the top portion level with bucket edge/ground and the back side returning to bucket as it slopes down.
airbiscuit
Super Member
- Joined
- Aug 28, 2004
- Messages
- 7,801
- Location
- NW Wisconsin
- Tractor
- New Holland T2310 (40hp), Kubota L3010 GST, New Holland TC21DA *** Previously - Farmall H, 1941 John Deere B, Shibaura SD1500, John Deere 850, Bobcat 642, New Holland 1925
Mine has a "Vee" that drops in place when the bucket is level. Really easy to see
