Box blade width?
- Thread starter Greenvalleymatt
- Start date
- Views: 4414
mwemaxxowner
Platinum Member
I will wind up with a quick attach for my pin on stuff from Tony at AI2. I have been mulling over the possibility of buying his blank plate, and seeing if I could weld the quick hitch from Harbor Freight to it to use 3ph stuff on the front.
That probably actually means I'll think about it but never try it
.
That probably actually means I'll think about it but never try it
.
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 13,298
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
If you do, be sure to build in some extra rollback like this 3 point adapter has:I will wind up with a quick attach for my pin on stuff from Tony at AI2. I have been mulling over the possibility of buying his blank plate, and seeing if I could weld the quick hitch from Harbor Freight to it to use 3ph stuff on the front.
That probably actually means I'll think about it but never try it
ovrszd
Epic Contributor
- Joined
- May 27, 2006
- Messages
- 33,727
- Location
- Missouri
- Tractor
- Kubota M9540, Ford 3910FWD, Ford 555A, JD2210
I used my level indicator to help me figure out that angle. Removed my bucket. Parked on flat floor with bottom of FEL QA plate about 4" above floor. Rolled FEL until the level indicator showed the bucket would be sitting flat on the floor. Then used an angle finder to measure the angle of the QA plate.
If you don't do this in some manner your new attachment will be difficult to use.
If you don't do this in some manner your new attachment will be difficult to use.
