3-Point Hitch Bouncing 3Point - Jinma 354

   / Bouncing 3Point - Jinma 354 #1  

cnsJohn

Bronze Member
Joined
Apr 21, 2012
Messages
50
Location
Lafayette, TN
Tractor
Jinma 354
I changed the hydraulic fluid and filter on my 354; now the 3pt bounces. The arms drop a few inches and the bounce back up to their set position. Any ideas for a fix?

Your insight and experience are greatly appreciated.

JohnJ
 
   / Bouncing 3Point - Jinma 354 #2  
Have you run it through several full cycles to purge any air in the system? Be sure to recheck fluid level afterword also.

Note: The only way you'll get a full cycle is to remove any implement and force the arms all the way down.
 
   / Bouncing 3Point - Jinma 354
  • Thread Starter
#3  
Thanks. I'm fixing to climb on it in a minute. I'll give it some cycles.

Thanks again for the suggestion.
 
   / Bouncing 3Point - Jinma 354
  • Thread Starter
#4  
CCWKen,

Seems no amount of lift arm cycling, without or with implement, has solved the bouncing issue. Any thoughts as to what else might be causing the problem?
 

Tractor & Equipment Auctions

Target Econline 2 Concrete Saw (A49461)
Target Econline 2...
2009 Peterbilt 384 T/A Wet Kit Day Cab Truck Tactor (A50323)
2009 Peterbilt 384...
2013 INTERNATIONAL 4300 26FT BOX TRUCK (A51219)
2013 INTERNATIONAL...
2000 John Deere 770CH Articulated Motor Grader (A49461)
2000 John Deere...
2003 MACK RD688S T/A DUMP TRUCK (A51406)
2003 MACK RD688S...
2015 JEEP PATRIOT (A51406)
2015 JEEP PATRIOT...
 
Top