Bolt on hooks
- Thread starter tradosaurus
- Start date
- Views: 11763
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,874
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
WranglerX
Super Member
Dale. I’m in Canada so your cost is 35 to 45 percent LESS than whatever I paid.
But how much even in Canadian dollars...
Dale
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,874
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
It looks like the two sets I have pictured would be about $350usd
My set (not in photo)that goes up to 1”d is only $80 usd on Amazon. For that set I recommend buying extra arbors so that you have one for each cutter without having to change.
WranglerX
Super Member
Ummm....
19 Piece, 5/16 to 1-1/2" Cutter Diam, High 4512135 - MSC
Think I will stay with my $54 15/16 inch "bridge" reamer...
But I guess it depends on what size hole one needs and how thick material is....
Dale
19 Piece, 5/16 to 1-1/2" Cutter Diam, High 4512135 - MSC
Think I will stay with my $54 15/16 inch "bridge" reamer...
But I guess it depends on what size hole one needs and how thick material is....
Dale
Last edited:
atsah
Elite Member
And how many times you intend to use the tool.
WranglerX
Super Member
So far its drilled 30+ holes... Out to 13/16 for 3/4 inch clearance .... Used a sleeve made from PVC pipe to limit depth/diameter, but actually got it for clearance holes for 7/8 Cat 1 pins to adapt pin locations and such on any implements I need to modify...
I also used at our local museum putting a 10 HP motor and shafts and stuff and making brackets to support bearings to power a 2000 pound Joshua Hendry ore crushing stamp mill.... Everthing is 3/4 bolting material....
Our "2" Stamp Mill – Mariposa Museum & History Center
Dale
jmc
Elite Member
- Joined
- Jul 21, 2003
- Messages
- 3,100
- Location
- SW Indiana
- Tractor
- Ford 1920 4x4 (traded in on Kubota). Case 480F TLB w/4 in 1 bucket, 4x4. Gehl CTL60 tracked loader, Kubota L4330 GST
Had to look it up. If we had any in Indiana, they were probably used on grain! Pretty cool...
WranglerX
Super Member
Also have 5000 pound 5 stamp mill.....I get to run/repair/build the great gold rush era machines....
Our “5” Stamp Mill – Mariposa Museum & History Center
Video sort of sucks but its all we have for the moment... Guy in video is one of my cohorts in crime when it comes to running/maintenance... In video we are doing it for a school tour for part of their California history...
Dale
bmoore
Member
So it was a little scary drilling holes in a brand new tractor, but I got my hooks from Ken installed today. Easy 15 minute job.
