goeduck
Super Member
Another BB work of art in progress 
Looking forward to the end product....
Looking forward to the end product....
Big Barn’s Retirement Farm Shop
- Thread starter Big Barn
- Start date
- Views: 815152
OP
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,874
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
I did it outside and surprisingly enough it wasn’t nearly annoying as a dry cut chop saw.
A little slow and tiring for my liking though.
dragoneggs
Super Star Member
- Joined
- Jun 9, 2013
- Messages
- 13,627
- Location
- Seabeck, Washington
- Tractor
- Kubota BX-25D, Kubota Z122RKW-42
And what exactly is that saw? My first reaction was 'no way'. Photoshopped.
pmsmechanic
Elite Member
- Joined
- Dec 6, 2013
- Messages
- 4,226
- Location
- Southern Alberta, Canada
- Tractor
- 4410 and F-935 John Deere, MF 245
^^^ I'm thinking just a regular skill saw with a Princess Auto blade in it.
I made a spacer for my skill saw and use my chop saw blades in it. I use them down to 7.25 inches in the chop saw and then if I need to I can use them up more in my skill saw.
I made a spacer for my skill saw and use my chop saw blades in it. I use them down to 7.25 inches in the chop saw and then if I need to I can use them up more in my skill saw.
OP
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,874
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
OP
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,874
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
Holes drilled for clamps and 1940's Made in Canada Henry vise. Henry supplied vises for the WWII Allied forces
The front radius of the vise's base closely matched the 18" radius of the tabletop.
The front radius of the vise's base closely matched the 18" radius of the tabletop.
drivesitfar
Silver Member
How much do you think that table weighs? How much weight in the base? Nice looking for sure snd a great smallish vise should come in handy.
Geesh a skill saw and cutting 3/4 inch plate must have been tough. Looks like it worked though.
Geesh a skill saw and cutting 3/4 inch plate must have been tough. Looks like it worked though.
OP
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,874
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
Here's a pic of the circ saw I used
OP
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,874
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
This table is prob about 400 pounds. I haven't weighed it yet
Didn't need weight in the base. The top is heavy but only 36 inch diameter and the base is 22 inch diameter. At 32" overall height you can't tip it.
The other larger diameter table will need a heavier base though.