I have an MF202 industrial with a front loader and would like to get a BH attachement. I am a bit new to this and I am not sure exactly what I should be looking for. I would like a BH attachement that connects to the 3 pt hitch, the loader has a pump that could also be used for the BH. I know the 202 came with a custom BH but I would like to get one that attached to a standard hitch that I could still use if I replace the tractor. Any thoughts would be helpful
Back Hoe for MF202
- Thread starter richn
- Start date
- Views: 1249
JerryG
Super Member
If you was to run across one of the original hoes, it would be a much, much stronger hoe. There is no comparison between the factory hoe and a three point hoe.richn said:
erich
Bronze Member
- Joined
- Nov 11, 2001
- Messages
- 83
- Location
- New Salem, Massachusetts
- Tractor
- Massey Harris 50 & Massey Ferguson 35
RichN
The old Davis 185, 210 & 220 backhoes would most likely be a direct bolt on. There may be newer backhoes that will work but those three were common for the era. I beieve the 220 was able to shift side to side on rails. The 185 and 210 could be bolted to the middle or either side of the frame.
I have a Ferguson 35 with a 210 backhoe. The MF 202 would be much better suited for the BH than my 35.
BTW wherabouts do you live?
Erich
The old Davis 185, 210 & 220 backhoes would most likely be a direct bolt on. There may be newer backhoes that will work but those three were common for the era. I beieve the 220 was able to shift side to side on rails. The 185 and 210 could be bolted to the middle or either side of the frame.
I have a Ferguson 35 with a 210 backhoe. The MF 202 would be much better suited for the BH than my 35.
BTW wherabouts do you live?
Erich
