B7800 rear remote question

[dirtdiggerdug]

I have a Kubota B7800 with a BH. There are 2 hoses that run from the FEL valve to the rear of tractor. When these hoses aren't being used for the BH, they are connected into each other. I would like to add a rear valve to control a cylinder on my sickle mower This cylinder is used to raise and lower the cutter bar. Does anybody have a setup like this on there B7800? if so, what type or kind of valve do you use? Would appreciate any info I can get and thanks.

 

[kennyd]

Doesn't have to be a b7800 or even a Kubota...the principle is the same on all modern tractors.

You need an open center, 4-way, spring return to center valve like THIS if you just want one spool. Then you need the proper QD's and you are all set.

 

[dirtdiggerdug]

Thanks Ken for the info. Just what I needed to know.