B3300 Front axle oil

   / B3300 Front axle oil #1  

kkcomp

New member
Joined
Dec 13, 2014
Messages
8
Location
Jacksonville, FL
Tractor
Kubota B3300SU
I am probably going to go duh but how do you add oil to a B3300 front axle? I can easily find the vent pipe and the big yellow cap but is the cap a twist off or a pop out? I have turned it many times but it just turns. If it is threaded I don
t want to just yank it out.
 
   / B3300 Front axle oil #2  
It's just a push in plug. I use a pair of slip joint pliers to get a better grip on it, then twist as I pull up.

Joe
 
   / B3300 Front axle oil
  • Thread Starter
#3  
It's just a push in plug. I use a pair of slip joint pliers to get a better grip on it, then twist as I pull up.

Joe

Got a chance to try last night. Had to eventually get a screwdriver under it and pry it out. Once out I found that some fine sand was around the plug making it stick. Cleaned it off with a bit of 600 grit and put petroleum jelly on it. Still a good fit but can remove it by hand now. Thanks for the reply.
 
   / B3300 Front axle oil #4  
Got a chance to try last night. Had to eventually get a screwdriver under it and pry it out. Once out I found that some fine sand was around the plug making it stick. Cleaned it off with a bit of 600 grit and put petroleum jelly on it. Still a good fit but can remove it by hand now. Thanks for the reply.

I've heard that petroleum jelly can have a bad affect on rubber components. I would use plumber's grease. It used on O-rings and similar type components for a better seal in plumbing. And if it's safe for drinking water, you know it's non-toxic.
 
   / B3300 Front axle oil
  • Thread Starter
#5  
I've heard that petroleum jelly can have a bad affect on rubber components. I would use plumber's grease. It used on O-rings and similar type components for a better seal in plumbing. And if it's safe for drinking water, you know it's non-toxic.

I have been using it for decades and never had a problem. BTW nice picture.
 
   / B3300 Front axle oil #6  
I have been using it for decades and never had a problem.

Same here. For over 40 years I have been using vaseline when installing radiator and heater hoses on everything from cars to highway rigs to bulldozers and never have had a problem. It makes the hoses much easier to remove when required. Just my experience.
 

Tractor & Equipment Auctions

2014 INTERNATIONAL PROSTAR (A50854)
2014 INTERNATIONAL...
Kubota 24in Quick Attach Compact Excavator Tooth Bucket (A51039)
Kubota 24in Quick...
2013 Ford Econoline E350 Passenger Van (A49461)
2013 Ford...
2013 Chevy Silverado 2500 HD (A51039)
2013 Chevy...
80in HD Tooth Bucket with Side Cutters ONE PER LOT (A51039)
80in HD Tooth...
2006 CHEVROLET SILVERADO 4X4 PICKUP TRUCK (A51222)
2006 CHEVROLET...
 
Top