GSmith4965
Bronze Member
- Joined
- May 23, 2009
- Messages
- 75
Hi
Just recently bought a b2320 with a loader and a few other attachments. I just finished assembling my b2763a front blade and quick hitch. There are two quick hitch rear brackets that attach to the tractor frame. From the schematic these look like they use the same tractor frame holes as the loader uprights.
My question is this. Has anyone encountered this? Can u use a quick hitch without removing the loader uprights ? Thus would be a real pain if u had to. If you amounted them over the loader uprights the width would be too wide (by the thickness of the loader upright flange on each side and the quick hitch mounting pin would be too short by the same amount. Am I missing something? Thanks in advance for advice!!
Just recently bought a b2320 with a loader and a few other attachments. I just finished assembling my b2763a front blade and quick hitch. There are two quick hitch rear brackets that attach to the tractor frame. From the schematic these look like they use the same tractor frame holes as the loader uprights.
My question is this. Has anyone encountered this? Can u use a quick hitch without removing the loader uprights ? Thus would be a real pain if u had to. If you amounted them over the loader uprights the width would be too wide (by the thickness of the loader upright flange on each side and the quick hitch mounting pin would be too short by the same amount. Am I missing something? Thanks in advance for advice!!
