Anyone have a good design for a protectove PTO cover?

jodebg · Dec 5, 2013

Would like to make a cover for the mid and rear pto's.

Any ideas? Thanks.

murphy1244 · Dec 5, 2013

jodebg said:
Would like to make a cover for the mid and rear pto's.

Any ideas? Thanks.

for what tractor?

jodebg · Dec 5, 2013

kubota b7800

k0ua · Dec 5, 2013

I thought all the Kubota's came with a simple rubber/vinyl slip cover. Mine all did. I imagine there is a part number?

ferrari99 · Dec 6, 2013

bare-co.com

weedpharma · Dec 16, 2013

If you are referring to a cover for the PTO splined power take off, I simply used a piece of poly pipe and a short piece of wire to hold it on. It's not fancy but it's cheap!!

Weedpharma

jodebg · Dec 16, 2013

Kubota b7800.

The owner's manual shows a hinged c-shaped cover sitting above the rear pto shaft. Don't know if this was
original to this tractor and if I should consider replacing it? Also, looks as if it had a round shaft cover, as well.

jodebg · Dec 20, 2013

Mission accomplished. While shopping in our local Big Lots store I came by a set of 4 heavy black plastic Keeper Bed Risers.

They fit great and completely cover the rear pto. Just drilled 2 small holes in each side and fastened with 2 black wire ties.

The price for a package of 4 is only $5.

Very sturdy and the way they are designed, they are out of the way of the PTO operation.

Need to hook up to the PTO, just cut the 2 wire ties and you are ready to go.

I will post a photo asap.

k0ua · Dec 20, 2013

jodebg said:
Mission accomplished. While shopping in our local Big Lots store I came by a set of 4 heavy black plastic Keeper Bed Risers.

They fit great and completely cover the rear pto. Just drilled 2 small holes in each side and fastened with 2 black wire ties.

could you post a picture? It might help others.

James K0UA