joecoin
Gold Member
Can you get close and use a winch?
Anyone build or make a trailer dolly?
- Thread starter Mousehunter
- Start date
- Views: 6889
Can you get close and use a winch?
OP
Mousehunter
Member
Where there is a will, there is a way. That said, think I might have stripped out my lite duty warn winch doing a bit too much of that. It was never meant to winch my 50hp Ford tractor onto a lowboy.
That said, I need to play musical trailers soon and I might just end up using a comealong before it is over.
?
Still fence sitting on the BCS. Waiting to see how much overbudget I go on fencework before I start ordering a tractor
That said, I need to play musical trailers soon and I might just end up using a comealong before it is over.
?
Still fence sitting on the BCS. Waiting to see how much overbudget I go on fencework before I start ordering a tractor
aczlan
Good Morning
- Joined
- Mar 7, 2008
- Messages
- 16,985
- Tractor
- Kubota L3830GST, B7500HST, BX2660. Formerly: Case 480F LL, David Brown 880UE
Hmmm, interesting thread. I got a older Mainline Mountaineer II REV1500 a few weeks back, it has turning brakes and seems fairly beefy. If I can get it to stop leaking (the input shaft and PTO shaft on the transmission leak) and run happily, I think I will set it up as a trailer mover with a heavy swivel wheel in the front and a 2" ball and a pin hitch over them so I can use it to push the hay equipment around in the barn when I am nesting it in there.
Aaron Z
Aaron Z
Attachments
A heavily weighted wheel attachment would be key to balance the engine when there is no trailer on the hitch. Good idea!Hmmm, interesting thread. I got a older Mainline Mountaineer II REV1500 a few weeks back, it has turning brakes and seems fairly beefy. If I can get it to stop leaking (the input shaft and PTO shaft on the transmission leak) and run happily, I think I will set it up as a trailer mover with a heavy swivel wheel in the front and a 2" ball and a pin hitch over them so I can use it to push the hay equipment around in the barn when I am nesting it in there.
Aaron Z
OP
Mousehunter
Member
Barn floor is not as level as I hoped. Spent about an hour with had and come-a-long today moving a small trailer. Almost got it were I wanted it when it jumped over my makeshift wheel chokes and rolled back where I started. Will try again when it is not raining and the trailer is not loaded.
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 12,889
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
Can you adapt this style trailer mover to the BCS?
