Did some bush hogging Saturday with a Howse 6' mower pulled by my 38hp Antonio Carraro 4400 TTH. Some of the stuff mowed down was 3 year old gum saplings in a ditch. At one point the back wheel fell into an unknown ditch and my pucker factor immediately jumped 10X. The articulating frame let the back end roll down into that hole while the front wheels did not tilt one bit. It once again confirmed it to be a good machine for the hilly lot behind our business.
Anybody Here Own an Antonio Carraro 4400 TTH?
- Thread starter wstr75
- Start date
- Views: 86516
ptsg
Super Member
Yes, there is. It's very important to keep it greased.
Check this manual. Towards the bottom, there is a picture with all the grease zerks. I don't know if it's the same model as yours but should be same when it takes to grease points.
thank you. Here is my new work toy. TTR4400 HST II 2020. I have had it for a month and the tractor now has 71 hours.
In the manual that you sent me the link it only mentions the front and rear 3-point, the steering and the pedals to be greased. That's why I wonder if there is something on this model.
In the manual that you sent me the link it only mentions the front and rear 3-point, the steering and the pedals to be greased. That's why I wonder if there is something on this model.
Attachments
ptsg
Super Member
Nice tractor!
I'm pretty sure it should have more grease zerks, specially for the Actio oscillation which is very important to keep greased on these style of tractors. Also, I think there are some U joints that need grease too.
You may have to dig around the tractor and look for grease zerks or maybe ask your dealer.