Another Rooting Bucket!

[Spencer]

Here is the <A target="_blank" HREF=http://www.tractorbynet.com/cgi-bin/compact/showflat.pl?Cat=&Board=buildit&Number=202071&page=&view=&sb=&o=&vc=1>link</A> to Randy's earlier post "Shrub Removal Bucket". I guess I was too busy in October to see the post then. Good job Randy and Greg.

 

[Gfranklin]

Thanks for the comments everybody!

Greg

 

[Anonymous Poster]

Good job, Greg!

I just have to get enrolled in that welding class I want to take!

Looking at your work, I keep thinking "I could make one of those!!!!"

Out of plywood.../w3tcompact/icons/laugh.gif

Bill in Pgh, PA

 

[JDGREEN4ME]

The bucket looks great I wish I could weld without hurting myself or someone else.../w3tcompact/icons/blush.gif

 

[Gfranklin]

Re: Math Error!

A correction here. The whole reason for some of my direct-on shots were to grab some dimensions and angles from the pictures. So I kick back in my chair, hold a compass up to the monitor and...... Oops, the angle is not what I stated it to be! I rechecked my math, er.. AutoCad and the angle between the bucket bottom and backplate is 79 degrees. Just in case someone is looking closely.

Greg

 

[mrcaptainbob]

Re: Math Error!

I saw that. I figured it to be around 78.655 degrees. But that was just a rough guess off the screen......Didn't want to bring it up so as not to embarass....../w3tcompact/icons/laugh.gif/w3tcompact/icons/laugh.gif/w3tcompact/icons/laugh.gif