ADDING POWER STEERING TO TRACTOR

   / ADDING POWER STEERING TO TRACTOR #1  

redrockerx4

New member
Joined
Jun 12, 2012
Messages
2
Location
prince george BC
Tractor
IH
Greetings all,

i am converting my steering to power via a hydraulic steering cylinder with a priority flow control valve which is supposed to give my steering hydraulic priority over my existing front end loader.

i am doing this on an older IH B414. I guess all B414's are older aren't they?

can anyone tell me where the ports are supposed to be connected to on my new priority flow contol valve.

Its a Prince model RD400-R

The ports are labelled as follows

IN
PRIORITY
EXCESS FLOW
TANK

i am trying to plumb this into my existing front end loader controls.

If anyone could perhaps post a rough sketch or perhaps just an explanation, this would be greatly appreciated.
 
   / ADDING POWER STEERING TO TRACTOR #2  
Logically, flow from the pump goes to the IN port of the RD400R first.

http://www.princehyd.com/Portals/0/products/valves/catalog/valvesRd400.pdf

http://www.surpluscenter.com/Instruct/I9-4158-15.pdf

There is a relief for the priority circuit and the relief output goes to tank. It is factory set at 1500 psi.


The number to the right of the 400R, is the GPM for the priority flow. This will determine how fast the steering will operate.

Priority goes to the steering control valve. You always want steering.

If your priority valve is 2 GPM and the hyd pump is a 10 GPM, then the priority will always get the first 2 GPM, and the FEL will get the rest of the pump flow. Pump volume is determined by the engine rpm. At idle or slow and steering, you may not have flow to the FEL.

Excess flow goes to the IN port of the FEL valve.

Tank goes to any tank return line.

That is my interpretation.

This is a sample pic for a IH, not yours.

http://www.powersteeringkit.com/inter.html
 
Last edited:
   / ADDING POWER STEERING TO TRACTOR
  • Thread Starter
#3  
Thanks J_J,

Your interpretation looks pretty good to me.


i was under the false impression that the priority valve inlet was in parrallell with the inlet of the FEL controls

i am going to move my B414 into the 19 century now, man is it going to be a pleasure to drive then. Hopefully i can then convince my wife to drive the tractor.

regards

redrocker
 

Tractor & Equipment Auctions

2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
2008 AAR MOBILITY SYSTEMS REFRIGERATED CONTAINER (A54607)
2008 AAR MOBILITY...
JLG 1255 Telehandler (A55218)
JLG 1255...
2017 TRAILSTART 40FT DUMP TRAILER (A54607)
2017 TRAILSTART...
2011 Toyota Corolla Sedan (A53117)
2011 Toyota...
2013 INTERNATIONAL REEFER TRUCK (A54607)
2013 INTERNATIONAL...
 
Top