Adding light switch to NX

[justman777]

Want to add a switch on the right column of my NX by removing one of the blanks where all the other light switches are. I ordered a standard rocker switch off Amazon, but it's sloppy in the fitting. Does anyone know of a switch that'll fit that I don't have to pay a dealer $50 for? For clarification, I want to add the switch to the right column where all the other light switches are. On the NX cab model, this is right above the PTO switch/knob.

If I can't find a reasonably priced switch that'll fit, my plan is to make do with some hot glue to the back side. Any other ideas?

Thanks!

 

[Roadworthy]

Take some careful measurements of an existing switch which fits. Surf eBay for one with that configuration and those dimensions. That's how I found a replacement rocker switch for my welder.

 

[MinnesotaEric]

I made a standard Carling switch work but I shimmed it with part of the blank you pulled out.

 

[justman777]

Thanks!

I wound up resorting to hot glue. Seems to be holding just fine! Used it for some LEDs on the sides.