Rear Blade Adding hydraulic angle to rear blade

[BIG DOOLEY]

Great job BD as usual!

If I may offer one suggestion when posting pics, please add a space in between them so they don't look they all run together.

Never tought of that.
Much easier to fabricate blindfolded that post a thread.
I'm learning in progress
Can do, I had a little trouble with that myself.
Thanks.

 

[devildog1]

Kudo's on a great job of fabricating the hyd angle of your rear blade, looks great .
DevilDog

 

[94BULLITT]

Nice work Tom.

 

[etcallhome]

Very Nice

 

[94BULLITT]

A hydraulic side link with float would work good with the power angle for snow removal.

 

[BIG DOOLEY]

Thanks guys.
My order from Surplus Center was picked today, shipped today?
Home with a bad cold the last couple of days.
I hope to feel well enough to go to work tomorrow.

 

[OrangeToys]

Just found a project for my blade!!!! Looks good

 

[MtnViewRanch]

Just found a project for my blade!!!! Looks good

For your 8' blade, I would think about using a 3 1/2" x 14" cylinder. If you look to see what the OEM guys use, I'm pretty sure that none of them use anything smaller than 3 1/2".dia cylinders. I know that Land Pride uses a 3 1/2" x 14" for your size of blade.

 

[OrangeToys]

For your 8' blade, I would think about using a 3 1/2" x 14" cylinder. If you look to see what the OEM guys use, I'm pretty sure that none of them use anything smaller than 3 1/2".dia cylinders. I know that Land Pride uses a 3 1/2" x 14" for your size of blade.

Thanks for the info Brain

 

[BIG DOOLEY]

I finished the fabrication on the blade.
The cylinder and hoses should arrive UPS tomorrow.

Tom