3pt & fel forks

[jwaynejtx]

I used two old Jeep bumpers I beefup to build forks for 3pt & FEL .First use to unload new welder my son bought last weekend .

 

[Chuckanut]

Very clever! Set up for both front end loader and rear 3pt

Just out of curiosity... did you unload your son's welder in to YOUR garage?

 

[3RRL]

Yeah, I like that set up. Nicely done!

 

[Zick]

Nicely done. I was thinking about doing basically the same thing with my 3pt forks but I think I'm gonna make another set of fork because I don't like the fact that my rear 3pt forks aren't adjustable just like yours. It would be nice to move them around for different situations.

 

[George2615]

I made a set of forks a few years ago that slid on my bucket and tightened down with a T-handle screw (You can see the T-handles I cut off in the background of pic 2). I liked jwaynejtx's idea and modified mine so I can use them front or back. Mine are also in fixed position but I rarely need to adjust them. This was my weekend project.

 

[George2615]

Here's a few more. Thanks for the idea jwaynejtx.

 

[aczlan]

what do you use to keep the forks from sliding back into the bucket???


Aaron Z

 

[jwaynejtx]

yes Chuckanut unloading the welder was their first job, no in his barn, he has my wire welder, you know kids what yours is theirs to. Georg2515, I like your old ford here's a picture of my 36 ford.

 

[jwaynejtx]

Aezlan ,I haven't had it move back ,but I will put a stop at the bottom front of the bucket. A picture form right side.

 

[jwaynejtx]

George2515, I like your removable hooks on top good idea & handed.

 

[George2615]

Aaron, If you look at this pic you'll see the forks can't go back in my bucket.

jwaynejtx, Mine is a 29 Durant. Also I put the removable hooks there since sometimes you need to wrap a chain around what you are lifting and need a place to hook to.