3PT Change over

[Geneha]

I have a Kubota B7500 HST and just love this tractor. The 7500 has basically a up/down 3 PT and is sometimes had to get the height set right. The B7510 HST, same tractor but has the incremental 3 PT system, where to set the lever to a specific spot and the 3 PT goes to the same height.

My question is what would it take to make my up/down into a incremental like the 7510 or is that a huge undertaking like changing out the back half of the tractor.

Thanks and regards

 

[Don87]

I have a Kubota B7500 HST and just love this tractor. The 7500 has basically a up/down 3 PT and is sometimes had to get the height set right. The B7510 HST, same tractor but has the incremental 3 PT system, where to set the lever to a specific spot and the 3 PT goes to the same height.

My question is what would it take to make my up/down into a incremental like the 7510 or is that a huge undertaking like changing out the back half of the tractor.
Thanks and regards

More than likely. But an alternative may be a 'guage' wheel on your attachment to stop at a predetermined point.

Post number 16 in this thread shows 1 design: http://www.tractorbynet.com/forums/build-yourself/145580-disc-plows.html