3Pt Adjuster link IHC 424
- Thread starter dieselscout80
- Start date
- Views: 2158
DJ54
Elite Member
- Joined
- Jan 20, 2009
- Messages
- 4,639
- Location
- Carroll, Ohio
- Tractor
- IH Farmall 656 gas/ IH 240 Utility/ 2, Super C Farmalls/ 2, Farmall A's/ Farmall BN/McCormick-Deering OS-6/McCormick-Deering O-4/ '36 Farmall F-12/ 480 Case hoe. '65 Ford 2000 3 cyl., 4 spd. w/3 spd Aux. Trans
I looked on Case/IH parts list for the adjuster for your tractor. They make 2 versions. One like yours, and another that the crank is almost verticle, out the top, but at a slight angle. Looks to be a little more user friendly from the operator's seat.
I googled the part number, for one like yours, and noting appeared. However, the other assembly came up with many results, and are used on lots of models.
New aftermarket adjuster assemblies can be bought in the $80 to $90 range, from just the few I checked out.
Here is the part number if you care to copy and paste, and do a search
3069056R91
I googled the part number, for one like yours, and noting appeared. However, the other assembly came up with many results, and are used on lots of models.
New aftermarket adjuster assemblies can be bought in the $80 to $90 range, from just the few I checked out.
Here is the part number if you care to copy and paste, and do a search
3069056R91
sweettractors
Advertiser
I checked with A&I aftermarket and they are only showing the crank lever coming out the top for the 424? That is unusual. Ken Sweet
OP
dieselscout80
Veteran Member
The one from the top would not be bad it would be easyer to reach from the seat. When I looked I didn't see any on their website.
Here are some IH part #
3Pt Adjuster link IHC 424 - Red Power Magazine Community
