3 point won't move

[careyo63]

Your control setting for the lift and lower is the pin on the side of the Hydraulic valve. The pin is usually in the middle upwards position. You can see it if you look hard. I do have a 240 manual that covers it. The files to big so PM. me if you don't have a Manual and give me a E-mail. I'll send it that way!

Attachments

• 
  002 (3) (600 x 450).jpg

  200.8 KB · Views: 338

The big issue still is do you have Hyd. Pressure?

 

[jrailey470]

Your control setting for the lift and lower is the pin on the side of the Hydraulic valve. The pin is usually in the middle upwards position. You can see it if you look hard. I do have a 240 manual that covers it. The files to big so PM. me if you don't have a Manual and give me a E-mail. I'll send it that way!

Attachments

• 
  002 (3) (600 x 450).jpg

  200.8 KB · Views: 338

The big issue still is do you have Hyd. Pressure?

The loader works great so I would assume I have hydraulic pressure

 

[careyo63]

My guess. Put the arms on it an Push them down!

 

[jrailey470]

Pretty sure I figured out the problem, 3 point cylinder is rusty and the piston was stuck at the front of the cylinder

 

[careyo63]

Pretty sure I figured out the problem, 3 point cylinder is rusty and the piston was stuck at the front of the cylinder

Looks like the problem. My Org.2000 The Hyd. fluid was super nasty when I first changed it! 1" that was as thick as Crisco in the can on the bottom of the pan. Water Moisture and whale oil............