3 point hydraulics Max26

[vietvetharry]

I had to remove the FEL to weld the support frame that broke. I looped the two hydraulic lines that were going to the FEL controller thinking that would keep the system closed, but now the 3 point will not lift. Do I need to bleed the lines or do I have to reroute the hydraulics differently? HELP please.

 

[Joe Hickerson]

Hi Harry, there should be 4 hydraulic connections to the loader and disconnecting those should be the only thing 'ya have to do.....

Joe H.

 

[vietvetharry]

Thanks Joe, but I also had to remove the frame to have it welded and that required me to disconnect the joyshick and hydraulic lines. I capped the three connections on the hydraulic block that went to the FEL and the one that went to the rear for the backhoe. The 3 point still will not lift except by hand.

 

[Joe Hickerson]

Thanks Joe, but I also had to remove the frame to have it welded and that required me to disconnect the joyshick and hydraulic lines. I capped the three connections on the hydraulic block that went to the FEL and the one that went to the rear for the backhoe. The 3 point still will not lift except by hand.

Ok Harry, I got it now!! Have to draw me a picture..lolol. Guess I can't help in this regard. Hope 'ya find the cure!

Joe H.

 

[mike69440]

Can you post photo of what broke?