3 point bed edger?

[westbrooklawn]

Has anyone ever seen, or fabricated, a 3 pt. attachment that could be used to edge landscape beds? I'm thinking some sort of a small plow that would cut a "v" shape about 4" deep, and turn the cut sod towards the inside of the bed.

It seems you could mount this attachment in an offset manner so that it would ride at the outside edge of your rear tire track. Is there such a thing? Any ideas?

 

[RonR]

I have seen an edger; not sure if it was homemade or factory. It was a single flat coulter disk blade on the end of a 3PH bar. It was spring loaded, so it would hold pressure against a curb edge.

Always thought that would make edging along the street easy, but haven't built one yet.

ron