2120 front end leak

[Zerk]

I need 26 in the diagram for a 1995. Not sure I am reading right, 3 options. I think mine is not available.

 

[TractorTech]

Depends on year. Disregard NH-E for Europe, but the #26 I listed is the only one available. You might measure yours to see if #26 is long enough.
360mm = 14 1/8"

 

[Zerk]

Mine is 14". Maybe I will try to run to autostore today to see what they say and cost. If not order 14" hose from Mesecks.

 

[Zerk]

I haven't managed to get over to an auto store to ask. I just ordered it from messicks. Not cheap. No new holland dealer super close. One I went to closed. Not that there are not ones in driving distance.

The tractor is for my camp, so I need to work on it when I can. I will be staying there for work, so I need to take advantage of that. Wish I would have ordered right away, will be cutting close..


Also surely don't want to be doing this with numb hands in the winter.

 

[Btown]

If I remember correctly the hose comes in at an odd angle to the power steering cylinder. The end has a slight angle to it. They didn’t have that end to make it 1 piece. They said they might use about 1 a year and this is a cylinder and hose business. They were able to put 2 ends on to make the proper angle. There was plenty of room for it. Just be careful when you put the new hose on. I had my cylinder rebuilt, put it back on then a few days later it was leaking fluid. The hose was rubbing on the harmonic balancer on the engine. That’s why I had to have a new hose made. I put the new one on and zip tied it away from the harmonic balancer.

 

[Zerk]

That was not correct ho hose. Mine both ends are female. This male and female. I'll try auto store.

 

[Zerk]

two tractor dealers could not help. One sent me to industrial place. $36 while I waited at counter. $140 from messicks, and need to return.

British thread.

 

[TractorTech]

two tractor dealers could not help. One sent me to industrial place. $36 while I waited at counter. $140 from messicks, and need to return.

British thread.

Interesting. Nice to know.

 

[Zerk]

Two dealers said this is a metric thread can't do it. Which surprised, I figured was all metric. Kubota and New Holland.

 

[Zerk]

I just realized the old one, had sort of union, you put two wrenches on to tighten and loosen. This one where you would put the wrench to hold it is just the crimp. Hope there is enough room to get channel locks in place.

I would have preferred a regular wrench cause you can prop it against something to hold it in place. He also did not give me the old one.

$36, and I am going up this week, so I guess I'll find out.