Cudaone970
New member
I just purchased a ford/new holland 1715. When I turn the pto on, there is a loud noise emitting from that area. When you shut pto down the noise stops. Any ideas?
Last edited:
1715 pto noise
- Thread starter Cudaone970
- Start date
- Views: 1912
joecdeere
Veteran Member
- Joined
- Apr 13, 2002
- Messages
- 1,709
- Location
- Cumming,Georgia
- Tractor
- 1948 Allis UC Hi-Crop Cane 1941 Allis WC 1948 Allis G with loader, 1948 Allis G with dual disc 1948 Allis G 1948 Allis G 1949 Allis G 1954 Allis G 1959 Ferguson TO-35 1972 MF 135 1979 Power King 2418 1989 Ford 345C TLB
Most likely a bearing going bad, chipped or broken gear, or could be as simple as a snap ring has gotten out of its groove and let things move.
I'm not familiar with that model, but can you turn the PTO shaft with your hand with the tractor not running, You may feel the roughness of a bearing, or you may hear other noises to lead you to the problem.
PTO parts page - http://www.messicks.com/nh/59260?sectionId=11893&diagramId=59260_397470
I'm not familiar with that model, but can you turn the PTO shaft with your hand with the tractor not running, You may feel the roughness of a bearing, or you may hear other noises to lead you to the problem.
PTO parts page - http://www.messicks.com/nh/59260?sectionId=11893&diagramId=59260_397470
OP
Cudaone970
New member
I can turn the pto easily with no sound when the tractor is off.
Does the pot have play in it? There is a needle bearing on the tip of it that can come apart and cause catastrophic problems if not fixed. I just went through it with my 1910. I had a machine shop untemper, build up the tip and then retemper the pto shaft so it would fit the new needle bearing. Sadly, the rear seal is no longer available, but I found a new poly seal that fits on Amazon.
