155d hydraulic Question

[gary1611]

I have a Front plow Which i currently use a winch to lift because the dealer could not find the hydraulics. I want to make it lift with hydraulics. <font color="red"> Is there a Port that i can hook a hose into to control it with the three point control. </font> Or maybe somebody here has the parts to do it right i'd like down pressure but don't want to do to much fabricating right know. When i build a loader i'll control it with that valve but for know i just want to control it with three point.

 

[mark777]

Gary,

I think you will need a single controller regardless. You will have to tap into the pressure line on the bottom of your pump (small diameter line), run it to a single controller. like a log splitter controller for example, and to your implement and back to the high pressure side of the tractors hydraulics. I know of no other way to do it.

 

[lens12]

You can use the 3 point control valve , but it will not have down pressure because the 3 point control valve is a single acting valve. You'll have to do like Mark said for a dual acting cylinder.

 

[gary1611]

I understand that there is no down pressure with three point. was just asking if someone might have origanal plow hydraulic parts.
Can i just hook the into the port under the seat and to the rear of the tractor for up pressure. thankyou

 

[gary1611]

For those that may use this post in the future for reference. My answer is yes.
its a port under and to the front of the seat. Its inline with the 3pt stop valve. There is a port on either side i will try to update when i get it completed. Thankyou to those that replied even the ones who pmed me.