tank

40 Gal tank from TS. Not sure how old, but at least 4 years. Tank split on the seam above the drain, you can see it just below the label. How is the best way to repair? The split is about 1/2 way up the tank, about the 25 gal mark, only about 2-3 inches, but on the seam, and I usually only put...

Been thinking about adding filters to my transfer tank. The tank is 50 gallons and came from a reefer. Seems two filters would be ideal. Water and particulate. I have a cheap 12v pump that sucks the fuel from the top of the tank. The tube is about 2” from the bottom of the tank. I...

I finally had time to change the hydraulic oil in my AGT QK16R. People said the Chinese factory fluid could be used fryer oil for all anyone knew, so I chose Traveller. I was under the impression that the tank drain was situated so it could be swung over a bucket by rotating the cab, but I saw...

Hello, I have a M6060HD. The Fuel tank has grass particles in it. The CAB and ROPS models have different tanks. Has anyone removed the tank on the M6060HD without having to remove the left rear wheel? I have seen people do it (without removing the wheel) with the CAB model but the tank is...

I'm dealing with a hairline crack in my gas tank and noticed yesterday while checking on my patch job that after about 2 hours of mowing, the tank was extremely hot to the touch, like uncomfortably hot. I don't recall my gas tank getting hot like this in the past, but then again I'm not sure...

Bought an old house a few years back and the well has been cycling shorter and shorter as time goes by. There is no Schrader valve at the top of the tank, just a welded on stub. There is a Schrader valve located in the Tee where the tank is plumbed in parallel to the house supply. I assumed...

I have an LS 4140 with cab and loaded tires. Estimated weight is 5500 lbs. Would it be safe to drive over a septic tank buried 10” below grade?

What is the best way to drain this fuel tank?

does the tz24d have a pusher pump or is it gravity

I recently acquired an otherwise Nice 2013 ZRT 50 with 300 hours, model number 17AFCACP056, but the previous owner ran it without oil and seized the Kohler Courage 23hp engine. I got a Briggs 24hp engine with the same crankshaft and swapped. So far so good. Two quick questions: (And forgive...

My TYM doesn't have a coolant reserve tank. It has a Mitsubishi 3 cylinder diesel engine. I'm thinking I should add a universal reservoir. Any tips or suggestions?

It looks like the fuel tank outlet on my TC45DA is a grommet with a barbed 5/16” fitting pushed into it. See attached pictures (#20 & 21). Has anyone tried turning that barbed fitting to point to another location? I am wanting to add a pre-filter to keep my factory filter from getting so...

Hello everybody, I am not mechanical but am giving this a go. Last fall my tractor started overheating a bit. It got to the point that this morning I could only run it for about five minutes before it went into the red. Previously I had bought fancy air and water wands to clean out the radiator...

Probably varies by state, but i anticipate eventually selling my mid sized oxy/acet tanks. i bought them outright in mid 70'5 & still have ownership papers i will eventually sell them, but not sure how the ownership transfer is made & if it will be honored by a supplier. some companies only...

Deep well / tank question I never had a deep well before and probably should have done a some research before putting my well back together. I purchased a Florida property with a mobile home about the time Hurricane Helene hit. A huge tree landed square on top of the well. Parts, plumbing...

I have used Howes since day 1 in my tractor. Howes is a demulsifier not a water diffuser. I also use a water separator funnel. I have been adding the treatment to the container, filling the container and adding to the tank thinking the Howes demulsifies the water and the funnel removing it. Most...

I got a new expansion tank for my well pump. Inside there is a plastic like cap and when I pushed on it, nothing happened. Is that supposed to come out or move? I don't want to install it and find out that I needed to remove the inside or something wasn't correct with it. It also looks like it's...

Why wouldn't you stick a whole bunch of neodymium magnets on the bottom of the hydraulic oil tank next time the lid's off? All the steel goes down by gravity when it's still. If eqpt gets parked for a month I'll bet the steel drops to the bottom 100%. Now if there's a way to get it to stay...

I saw someone else using these and bought some to try myself, they work great for keeping trash out of the fuel tanks. https://www.amazon.com/gp/product/B0C86J98FY/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

Age and injury made 5gallon cans harder to deal with. Decided on Vevor 116gallon tank and pump. $733. Quickly shipped. Plastic tank has fork pockets. Tractors are poor fork lifts so needed to mount on pallet. $24 metal pallet from scrapyard much more durable, allows 4-way entry and takes bumps...

I'm thinking of installing this dessicant vent breather on my diesel tank. Does anyone have experience with using these or a good brand?

I have a tractor that mysteriously jack-knifed the rotary cutter into the hydraulic fluid tank and punched a half dollar sized hole in it. I am assuming that this is why the implements will no longer lift but at the end of the day this may end up being only part of the issue. In any event, my...

1987 Kubota L2250 with 358 hrs has rust holes on bottom of Fuel Tank (Diesel) After thorough cleaning of the inside, it doesn’t look too bad. I guess from water sitting in the bottom. I cleaned and wire wheeled the outside and looking for replies on an epoxy that I can use to repair the rusted...

Put this together to stop the constant leaking around the return hose on my shaver post driver. My kubota just has a plug, no threads. Driver dumps into the 5 gallon bucket. Bucket drains into tractor. Bought a bulkhead fitting from tractor supply. Bucket and old garden hose were typical...

Is there a screen in the fuel tank?

What do you do next if gas was put in the hydraulic tank? Engine was not started at all. Dig-It M2208 bucket loader.

Friend of mine has a 'new to him' XR3135 with about 600 hours on it. He let another guy use it, who proceeded to put about 5 gallons of GASOLINE into the tank, then ran it for a while still. This has led to sputtering, smoking, knocking, and who-knows-what-else. So, I'm trying to help him out...

23 years ago I had a 150 gallon bulk diesel tank in the barn on rollers because I was painting it. I went to work and the bulk driver filled it there. It's still there and a 90 gallon tank on rollers next to it. Concrete floor; nice new pole barn and 42x60x 14'H. I never saw a problem since...

2015 Tuff Torque K72 in a Deere X500 that began to leak transmission fluid; drips on cardboard after mowing. Not a lot; 1 ring the size of a silver dollar or so. After a few cleaning/mow/examine cycles it would appear source of leak is the input shaft seal. Don't know for sure, but its coming...

Where did you acquire your diesel storage tank? FB marketplace? New fabricator? Diesel supply company? Found on the side of the road?

While troubleshooting a loss of power/shutdown situation I decided to remove the fuel sediment bowl. Sure enough, the threaded part snapped leaving a part of it in the tank. There appears to be a nut on it (or something that looks to be welded on, maybe a mounting flange?). I've tried to...

I actually have THREE out of date 100 pound propane tanks. I don't know how many times they can be recertified, they've already been recertified at least once. I'm debating on just buying a new trio..... if I do, the question is, what might I look at doing with these? if I dispose of...

I have a Terramite T-7 very old I cannot seem to gwt all the rust out of the gas tank. I have tried vinegar and most of the store bought recommendations. The gas filters fill up with rust very quickly. Temporarely I have riged up a five gallon gas tank sitting on the left step. ANY HELP AT...

I brought my tractor home (from the rural property) for a few weeks while I sorted out some modifications. I added a diverter on the front loader, with a tank drain To plumb the tank drain, I brazed on an existing tank drain line. I brazed the bung on first, then drilled the hole though the...

Hello, new here. Does anyone know the trick to replacing the top belt that drives the transmissions on a Cub cadet M54 Tank? I have thought about dropping the rear axle just enough to clear the fans on top of the trans pulleys but don't know if that would cause other problems. Hoping someone has...

I have a storage tank with a pump and a typical fuel nozzle. However, the hose is really stiff. Is there a good FLEXIBLE 3/4” ?

I am about to add rear remotes to my LX2610 - I already have a 3rd function and backhoe. I have it basically figured out (thanks to Dan/Thisoldhokie !) and found some information. The way the LX2610 is configured, PB off the loader valve goes to the third function, which then feeds the backhoe...

Just pulled my fuel tank. Inside looks horrible. Looking for tank cleaning ideas.(before I start a web wide search. Seems to be quite a bit of good knowledge here.

Anyone had issues with fuel tank getting damage ? Looks like not the best place for it

Its been a while sense I posted anything. I have about 680 hours on my TYM t353 and had to replace control module at around 400 hours my 2nd problem is leaking fuel tank has anyone else have problems this problem. Tractor has done a great job! Ron

I've got an extra propane tank that I quit using since it has a leak in the shutoff valve, especially when going from closed to open or vice-versa. It's a Sherwood PV 14270. Can't find any online info on it re: repair parts. Have an email into Sherwood, but here's the question. There is a...

The original plastic fuel tank on my 2006 PT-425 began to leak around the bottom hose fitting. I replaced it with a new aluminum tank purchased from Powertrac. I also replaced the fuel line and fuel filter and added a shut off valve (something that I've wanted to do for years). Not sure if I...

I am looking for a B and S Fuel Tank, OEM part #297257. I am even open to good used. This is an old 70's engine, but runs great. Gas Tank rusted through.

Have a Deere R70/R72 riding mower I recently refurbished. Has a gravity feed tank feeding a now 12hp single cylinder B&S. Original gas cap was vented and in bad shape. I ordered a replacement part from Deere and got the part that superceded the original which fits but is not vented. Didn't...

I'm currently using 5 gal poly fuel cans for gas and diesel and put them on the ground when I fill them. I'm contemplating going up to 10 or 15 gallon cans, and I know they make 50+ gallon poly tanks with pump that have fork slots in them. All those sizes pose a problem getting back into the...

I just bought a FIMCO 40 gal three point sprayer and spent a couple hours putting it together yesterday. I'm going to have to figure a way to connect the electric next. It seems well designed and sturdy. Came with yellow Tee Jet nozzles. The tank has no fill marks to judge the amount of fluid...

Hi from a German Yanmar Owner, I've been reading here and at the Hoye forum for a couple of years now. I own a YM1510d since 2020 and I'm very happy with this little powerful tractor. I bought the tractor from a dealer who mounted already a FEL. Back in 2021 I updated the maual steering to a...

Hi I'm new to the group and I'm working on a free Ford 3000 diesel. It's not locked up so that's a plus. Was told it was having issues with getting fuel. So I'm going to start with cleaning the lines then go from there. The question I have is are all of the Ford 3000 fuel tanks the same? They...

First of all Hi to everyone I'm new here so if I screwed up be nice I learn quick.... I have a simple question: On the tractor above should there be some kind of gasket or seal between the filler neck and the fuel tank? Mine was "glued" on(and the glue failed) which I initially thought was a...