kubota l2650

I’ve located the window to see level of hydraulic fluid, but isn’t there suppose to be a dipstick also to be accurate. It is a Kubota L2650

My stater relay behind dash shows continuity across output when coil is not energized. Would think that should be open

I was box blading my driveway for the first time in 30 years with this freeze. After about an hour I heard noise from the engine and saw a puff of smoke out the left side and an eerie belt noise. I shut it down right away and inspected it. I could turn the radiator fan manually so it isn’t...

I'm trying to help our local Homeowners Assn. sell its tractor. It's a Kubota L2650. Serial #L2650D-50186. I THINK (not sure) it was manufactured between 1990-1993 based on the S/N but I could be off. It has a Kubota LA450 bucket and a Kubota backhoe model 4672A. It has 1,360 hours and is 4WD...

I am the proud new owner of a mint condition L2650....now I知 finding it difficult to source a fel. I知 not stuck on a kubota loader. I would appreciate any info on oem or aftermarket loaders that would fit this tractor. Thanks in advance.

Tractor is fairly new to me, first winter with it and temps have been 12-30 degrees F for the last 10 days..... Kubota L2650, Shuttle Shift, 4x4. 2500 Hours. This may be an "everclutch" model but it is new to me and I'm still learning this tractor. factory front end loader, has prompt response...

I have a 1995 Kubota L2650 where the PTO will no longer turn. Well, most times anyway. It may turn for a few moments before the PTO disengages itself. And every time when I engage the PTO lever it clacks loudly and disengages itself within a few moments. I'm thinking one of the shear bolts...

Anyone know how to lubricate the front axle pivot joints on a L2650DT-7? I had to disassemble mine to repair a leaky seal on the back of the differential where the pinion exited. What has me scratching my head is that I see no way to lubricate this pivot joint in front or back of the front...

Was working tractor without issue when I and stopped for coffee. Half an hour later it would not start. Had to drag it in to the barn to get it away from horses. It did not pull easily. Brakes don't appear to be locked on and all transmission levers are in neutral positions. I have pulled...

The lever to raise and lower my bushhog or box blade keeps drooping down/forward instead of staying in one position, thereby causing the implement to go lower than I want it to because of whatever weight is attached to the three point hitch. How do I adjust the lever so I don't literally have...

Hello - I just picked up an L2650 GST yesterday. I was wondering how long it's supposed to take to shift between gears? It mostly comes to a stop before changing. It's about 20 degrees here. Do you have to use the clutch between forward and reverse? Does anyone have any of the PDF manuals for...

I just hooked up my rototiller after not using it for some time. I used it a couple of days and the second day I had intermittant trouble starting it while in the field. I would turn it off to do something and then get back on and it wouldn't start. I fooled around with the shuttle, gears...

Good Morning TBN! I own a very reliable Kubota L2650 that I use mainly for mowing my back field. I'd like to expand its capability by buying a front end loader for it, but I'm not sure if I should just sell it and buy another tractor that already has a loader or not. What do you think? What...

Hey All- So, I just picked up a 1994 L2650 with 480 hours on it and I have a few questions. I paid $6000 for the tractor and a 6' blade. I felt that was a pretty decent price, right? It's in pretty good shape for an 18 year old tractor (some worn paint here and there, everything else looks...

My elderly father recently bought an older L2650 with a MMM. After purchase we realized the check chains on the 3PH that control sway of implements attached to the 3PH had been removed by a previous owner. There is a bracket for the MMM bolted to one of the arms so perhaps the chains were...

I'm looking at a l2650. It has an everclutch sticker on it. What does that mean? When I drove the tractor, it was a little bit difficult to change gears. With the tractor stopped, I used the clutch but I would sometimes have to press the clutch a few times to get it in gear. Is this unusual...

Tractordata shows that the L2650 pto is independent. Is that accurate. I looked at a 93 model and the PTO stopped when the clutch was pressed. Maybe I don't understand what independent means.

New to forum and need input on a problem with my Kubota L2650 dual-clutch . . . The drive clutch recently started to slip occasionally. It doesn't slip all the time. Sometimes it grips, sometimes it slips when starting to engage. Pedal travel seems OK, about 1/2" of play before the linkage puts...

Which model would be a comparable upgrade from a L2650? Tractor will be used primarily to mow yard and maintain orchard. Also must have at least one pair of rear remotes. This tractor will also be used to maintain driveway and rake hay. Thank you for any and all input.

I just changed the hydraulic fluid on my L2650. I refilled it through the filler hole in front of the seat. I brought the level up to the middle of the sight-glass by the clutch pedal, halfway between the H and L symbols. What is the difference with filling it up at the hole in front of the...

I looked under my tractor yesterday for possible damage and noticed the adjustable brake rod/link was perfectly straight except the ends were slightly dog-legged. It sort of looks like: \______|_/ instead of like ________|_ though the up-angle is not as steep as my drawing, maybe 5 degrees...

If I hook up my bushhog and engage it, it takes very little load for the handle/lever under the steering wheel to disengage itself on its own. If I have no implements hooked up to the PTO and just move the lever to 840 RPM (low), it will spin properly. It is only under a load it pops out of...

The owners manual for my Kubota L2650 tells me that the hydraulic system in my tractor has a 7.5 gallon capacity. I recently drained the transmission / hydraulic fluid using the two drain plugs specified and I only saw about 1.5 gallon of fluid come out. However, before I drained the system...

I've damaged several pieces on the front of my 12-year-old Kubota L2650 and need replacement grill, headlights, and misc pieces. Can anyone recommend an aftermarket or low cost source for such parts?

Parked up my 12-year-old Kubota L2650 4WD two months ago. Today I went to fire it up and noticed nothing happened when I pressed the clutch. To get it in gear, I had to force the lever Forward on the gear shift and Slow (turtle) on the speed shifter. To stop, I had to kill the engine because...

Just wanted to get a feeel for what my L2650 is worth. It is a 1993 with 650 hours, GST 4-wheel drive. The front end loader is the LA-450A and the backhoe is the BL4590. Everything works great. The previous owner had it sitting outside so there is some rust and faded paint.

I'm trying to sell my L2650 GST 4wd tractor locally and not having many serious hits. I get calls nearly everyday, but nobody seems too serious. Maybe I'm asking too much or maybe the right guy hasn't come by yet. The tractor is in excellent mechanical condition with only 600 hours. It is...

I am looking at two used Kubotas at our local dealer: a L2650GST and a L2900GST. The 2650: 500 hours with loader, 4wd, 1994, turf tires the 29000: 200 hours with loader, 4wd, 1999?, turf tires What are fair prices for these tractors? Thank you Design

I am looking at a L2650 and will need a loader. Some people say to buy off brand, and others bleed orange. I am in need for some solid advice about which heavy duty loader to put on this tractor. If anyone has any experience that would be greatly appreciated. Thanks in advance.

Does anyone know what year they built the L2650? Also would like to know the hp of these machines. I've seen one advertised locally with 600 hrs and the asking price is $10k.

Does anyone know what year they built the L2650? Also would like to know the hp of these machines. I've seen one advertised locally with 600 hrs and the asking price is $10k. Thanks

I am looking at 94 L2650 w/FEL, R4s(loaded), 345hrs, good paint. The fellow is asking $9,500. Is that a fair price. Machinelink.com would suggest it is. Does this model have any known problem areas that I should checkout.

I am looking at a L2650 about 6 years old. It has a loader and a woods backhoe. It has 600 hours on it and it apears to be in good shape. He is asking 11000. Is this a good deal. Thanks for the help.

Looking at L2650 with 150 hours. Looks in great shape. Dealer is asking $7700.00. Is this a fair price?

A freind had a '94 L2650-DT S/N 60417 (~400hrs) stolen back in December '99 from his land in Lafayette Indiana and it was never recovered. I realise that some time has past but it may not have turned up on the used market right away so I just wanted to put a note out for anyone seeing one...

Hello, I am borrowing a friend's L2650 for a month while he is out of the country. It has a loader and backhoe. I have filled the backhoe hyd. fluid to full on the dipstick - he left me a 5-gallon jug. Is the fill cap on the tractor beneath the seat (red cap that states "oil") for the loader...