howard

Howard Reduction Gearbox for Fordson Major tractors, 4:1 ratio, serial#1762 Still in wood create with manual. Has original sticky protective coating. Says 224lbs but I think it is more. Unsure of exact year so far. Also thousands of other Howard parts I have to sort through. Price in USD.

My buddy got this from a old farmer's son who was downsizing...farm stuff. Since my buddy has one ,he is bringing it to me in a week or two. Not sure if it works etc. All I can find is 1979 advertising. Also getting some kind of pto driven screw?firewood processor? Any hits or ideas...

Looking for any assistance from anyone who has been able to source/replace Howard 2000 early 70's 3 hole clutch plates. Replaced my motor and now clutch won't engage so I'm guessing plates are too worn. Any help is much appreciated.

I have an old Howard rotovator rototiller (Model HN) with a 12 compression spring twin disc pad slip clutch. I had to replace the friction pads recently but found that the metal plate between the friction disc pads is deformed (no longer truly flat - see pictures). As a result one of the new...

I have an old Howard Rotovator rototiller with a 12 spring twin disc slip clutch instead of the shear pin type Universal Joint. A month or so ago the clutch started smoking. I adjusted the compression springs however since then my PTO spins normally but the rotor only spins above the ground...

I have an old Howard Rotavator Selectatilth that is missing the pto shaft and slip clutch. Does anyone know where I could find one? The shaft coming out of the gear box is 1.5" and has 10 splines. Also if anyone know what model this is that would help. The factory tag is missing. There is a...

Hi just joined hoping I can get some insights from some who are more experienced than I. I would like to change the gear oil in my pto tiller and I don't have a manual for it. Anyone happen to have info on a Howard HA 130 WU tiller as far as gear oil capacity and type needed. Also are there...