Search results

I know this is a relatively easy manual lookup stuff but you guys are always way more helpful. KIOTI NS 4710 - about 11 hours 1. I need to get a grease gun and do the fittings I suppose? Do I typically need a special fitting or are they pretty much standard. Can you over grease? Does any grease...

so i am pretty sure I left the rear implement in the up position last time I parked the tractor for a week or so. when I got in today I found the lever for 3pt lift all the way forward (which I never do). so I thought that was strange. but I started it up. and immediately found the 3pt lift to...

I built up the courage to do my first implement change ever this past weekend. Removed rotary cutter for box blade. I'm nearly positive I hooked it back up like it was but I'm slightly concerned. The pins for the stabilizer arms are in the last hole which kind of allows the arms to move a...

What are some projects you've attempted (and accomplished) with a tractor that may be considered abnormal? I'm talking about thinking outside the box (blade) to the max. I don't care if it was the absolute worst possible tool for the job. What are some innovative (or not) ways youve used a...

I recently purchased a KIOTI NS4710. This tractor lives on my undeveloped (but, now, looking better!!!) property, across a narrow stream crossing. too narrow/not straight enough (I think) for a truck/trailer capable of pulling the tractor to cross. Anyhow. Is it generally a good or bad idea to...

I know this is probably a question better suited for trial and error, or the owners manual. I have acces to neither of those things at the moment. so here goes. Kioti NS4710 - 7 hrs. 3pt is pretty jerky when lifting attachment (new/first tractor). it could be normal. I am not sure so I contact...

Would there ever be a time where I would want to buy a grapple (or any attachment) that is smaller than my footprint? What kinds of situations (other than being able to lift more because of a smaller/lighter implement) would it be advantageous? Any? or is it in absolute that you should buy to...

1. How easy is it to bend a 3pt connection or PTO? I've got some really thick briars mixed in with very small saplings. Typically, I need to back into these areas to cut them because there are larger trees on the other side that I can't really run over. I'm just slightly concerned that I am or...

How easy is it to hurt the system by introducing dirt through the hose ends? I just realized I may have done this the other day. Filter should prevent catastrophe, hopefully?

This should be an easy one. Does it matter which hydraulic hose from implement goes to which QD (male/female) on the tractor? My guess is it doesn't matter. Since there are two buttons on third function then my guess would be the hose only matters in that it changes the direction of the...

I noticed this today on my third outing with new tractor. has to be ballast liquid leaking, right? is this an issue? can't be a big leak. I don't think it could've been from another source. ground is BONE dry but it was sprinkling rain a tiny bit. the other tire doesn't look like that. obviously...

this is a dealer installed third function valve on Kioti 4710. Im a new owner so I'm not sure what I'm looking for but I'm guessing it's something fairly common. the hydraulic hoses on the attachment can fit inside of 3rd function coupler.

Assuming the flow is sufficient? I would figure they do, but there might be some general concerns regarding forces on the loader that wouldn't be present for a skid steer? looking at this front end auger in particular but asking, really, in general. https://mechmaxx.com/products/150155 this...

Hey guys. Enjoying owning my first tractor (NS 4710 HST CAB) but don't have too much idea of what I'm doing yet so a few questions. I know some of these are probably really lame questions so I apologize. Hardware/Equipment 1. The third function valve leaks fluid. Pretty badly if I accidently...