Search results

I have a MF 135. see pics for name plate on the tractor. I was told it has "assisted power steering?" Any way, a mechanic told me this. I think it needs some more hydraulic fluid for the assist. I have an owner's manual, but I can not find the location of the fill port. I looked at the...

I have a diesel MF 135 with no remote hydraulics. I would like to be able to operate a cylinder on a hydraulic box blade. this seems like a light load for hydraulics vs. a front end loader. my question is, will someone recommend a vendor for the conversion kit? the kits i have seen on the...

Hello all, i have a JD 4430 that is leaking hydraulic fluid around the load control shaft. I removed the load control shaft, pictures attached. I am guessing that i need to buy a new shaft because of the ridges on the old shaft. The ridges are not deep, but may be enough to cause a leak. I...

Hello, i have a John Deere 4430 with perma clutch. All hydraulic functions, steering, transmission, three point hitch are inoperative. My mechanic replaced the front hydraulic pump- i don't think he tested the pressure to this pump. Replacing this pump did not fix the problem. My mechanic...

I have a 1975 jd 4430 diesel tractor that is new to me. After start up, I notice smoke coming out of a tube that is located between the frame and the battery box on the right side of the tractor. The tube is pointed straight down. Is this some a breather tube for crankcase oil? Thanks, Carr

I have a question about the setup of an offset disc. Overall length of the rear gang is 131". The front gang length is 121" On the right side of the rear gang, the gang sticks out from the frame 44", on the left side it is 19.5". On the front gang, the right side sticks out 24", and the...

Does anyone have any experience towing a Miller SJ1 disc behind a 3/4 ton pick-up? It is too wide to fit on a trailer with out a permit. The gangs are 10 ft. wide, and the overall length is about 18ft. I have read about attaching a chain to the tongue of the disc, and then attaching the...

Anyone heard of a John Deere off-set, pull type disc that shows a model number 9PK-02 on the nameplate? An online search did not produce any results. The nameplate reads John Deere Killefer Works. The disc needs some new discs, a cylinder, new tires, and some spools. I was hoping to be able...

I have an Bobcat S220 s/n 526215341, 2005 model, heat and air. When I turn on the ignition switch, there are no lights on the panel, no fan noises, nothing. I checked the battery- appears good. I checked voltage to the 100 amp fuse by the battery- 12.5 vdc. I checked voltage on the side of...

This tree shear appears to be a Dymax, but I called Dymax for help and they can't identify it. The factory serial number plate is gone. The shear works fine, but I am concerned about keeping it working. The problem with the shear is that the two pins in the center that the blades rotate on...

Can someone help me identify this plow? I have used it on my Masey Ferguson 135 with limited success. The plow seems a little heavy for this tractor. I would like to use it for some small acreage planting, and fire breaks. The only identifying number is "G 882-A" and a small JD in a circle...