Recent content by Rocky J

Pictures of the 1964 Cub Loboy converted to propane . You can see the homemade orifice I made from a piece of rubber hose and inserted into the vapor feed line, the full 3/8 red rubber line would not even try to start the engine, the next orifice I cut was to small and would only idle , then...

This is what I did, yes it egg shaped the hose a bit.

What you are saying makes sense, welding the spring saddles on with a lot of weld and building a excess in heat could have pulled the carbon from the surrounding area of the axle tube around the saddle to the weld and making it softer and capable of bending .Everything I weld pulls some no...

This is the 220

-5 F or -20 Celsius here in Northern Indiana, do not hear the roar of the wind ,still dark but can see red lights on the wind turbines as far as 15 miles so can not be much going on. I hope all the rain turns to snow in the south with the temps they are getting, when we get the freezing rain it...

Morning , I have not seen anything good about it yet. -8 F outside and house is popping and clunking, have electricity this morning but did not Friday Morning . Roads covered with ice and traffic running at 5 mph. Schools closed, Wind chill advisory , This is one of the days the bottoms of my...

Got this 25% off coupons this morning and it said it can be shared

When the seal that divides the two sides fails there is no up side and down side, they connect and become one with a little restriction . Bypassing around the seal. The seals went bad in the Power Steering cylinder on my Jinma and you had to slowly keep turning the steering wheel to keep it...

I had that same problem with my loader, it would go down just as fast as it went up and it was the seals. In my case it was just O Rings and shims and wiper seals at the cost of $15 for three cylinders. I think mine had been rebuilt with the wrong O Rings and were not ment to be in oil , who...

25F this morning, moon so bright I thought there was a car in the drive with the headlights on aiming in the window. The last flu I thought I had I was going to stay in bed till it passed, wife called DR. and mentioned a new water heater installed and he said I would not have to sit in waiting...

From what I can tell from all the diagrams is both sides of the pump are putting out fluid until it reaches 500 psi back pressure then it opens a unloader valve on the high volume side of the pump and it just circulates and lets the high pressure side continue working. So it sounds like that...

Bright moon out there this early morning at 4 am, 34 Fahrenheit . Had to get up to load stove . I saw Eric was also up then I thought about him being 5 hours later then me. 4 am here and 9 am there.

I have a well so I have to ask how much money that 1650 gallons cost. You might have to install a holding tank to catch the shower water for the trees, When I bought the new washer I went with front load and was shocked when the owners manual said a top load was around 50 to 60 gallons a load...

41 degrees this morning and calm. to lazy to go out for some sugar maple to put in the stove and put in a piece of Osage Orange, just not cold enough for that yet, stuff is like hard coal, 85 degrees in here and window is up. I use a inversion table to get my back into the mood to cut wood, when...

I took a look at St Helens on the Google map and looked at pictures, your holding back mate , you could be giving us yanks bucket fulls of berries. That looks like a south seas Island fairy tale . Your worst day in the winter probably means you put on a long sleeve shirt over your singlet. I am...