Recent content by pcustoms

Tractor is a 2020 CK3510HSE (hydrostatic, SE, open cab) Seems to be a lot of reference for the F6800-16411 fuel filter, including my own manual. My tractor has a clear bowl and water sensor on the bottom. Looks like EH35-0011A based on what I was able to get from a cellphone pic (side with...

Thread bump. Ck3510SE open station, 255hrs. Ran it last weekend for a bit to move some logs and no issues. Calling for snow (finally) so I went to swap the grapple for the plow. Started and warmed up, shut it down to connect hydraulics and when I started up CEL was on. I think the code was...

Pretty sure those are the same lights I used on my ROPs. Or my truck, or my camper. I have lots of nilights, for the money a very good light.

Field install cab is dealer only? Mirror kit is dealer only?

That's cool, but the OP wants to add a snowblower....

Kind of makes you wonder.... I also noted that the manual recommends re-adjusting the slip clutch if the grinder has been unused, as the "tube" may be damaged and it will not be covered under warranty. Seems like maybe too light of a PTO? Looking at what was left, seems like I had plenty of...

Bumping the thread for the same problem. Cut my tube off @ the u-joint, then tried a weld bead inside the tube to shrink it. That was a waste of time and caused some issues. Then had to slit the tube and hammer it out. How in the heck am I supposed to get the new one in? 39", I can cut it...

Where did you find them so cheap? Best I could do was around $50, but shipping was almost the same. Used stump grinder, the overlap on the tubes was "enough" until I used it on a slope and almost slid them apart. Pushed everything together and then this happened about 5 minutes later Best I...

Well this: Definitely leaks! Polished the paint off and re-assembled with 4 new 116 size Buna-n 90A o-ring.

Thanks. I cracked mine loose to break the paint and then snugged it as right as I dare, no change. Parked the tractor and ordered a pack of o-rings before the flood started. There's a few other threads about this, yours was just the first I found.

@BrkMstr This was the o-ring in red, correct? At 239 hours, I was screening topsoil today (back and forth between 2 spots) and noticed some oil. After some cleanup ended up with the seat off and my leak is a drop every 3 seconds from here, I believe this is the opposite end from what you fixed:

What's the proper antifreeze? Mine appeared green, the manual is kind of vague and with the numerous formulations these days I'd like to avoid making sludge. Overflow is almost empty.....

I need to download this on my computer, phone scrolls horrible. I'm not sure it contains the SE diagrams. The SE(not cab) seems to be the redhead step child in the lineup....

I was looking at it yesterday and the plug on the backside of the cig lighter looked a little suspect. Was able to get a long flat blade driver in there and push it back together without having to disassemble anything Power! Certainly explains why I could not find a fuse issue. The cig light...

Lights are on a custom harness, that isn't the issue. Just had them plugged into my truck and everything works fine. The cig outlet is dead for some reason.