Quick Release Nightmare Kubota LA 682

   / Quick Release Nightmare Kubota LA 682 #1  

Oldtoad

Silver Member
Joined
Sep 28, 2018
Messages
181
Location
Kennebec County, Maine
Tractor
Kubota L4310, Bolens-Isiki
Bought a quick release setup had it welded up, assembled and plate welded to the bucket, just went to work.
Bent the whole mess so the quick release pads are wider than the plate and the bent linkage just adds to the pleasure. Cannot attach the bucket. Was not going fast but was firm.
Thinking of getting the ATI QA-KU1 about $865 The bent up mess on the end of the lift arms looks like junk to me. Opinions please...
 
   / Quick Release Nightmare Kubota LA 682 #2  
Pictures please. Of the bucket plate and the loader mechanisms.
Otherwise it hard to give an opinion.
 
   / Quick Release Nightmare Kubota LA 682 #4  
Does this show the problem clearly?
View attachment 659685
Needed a little space
View attachment 659684
Looks like the welds need to be cut and the plates moved inward.

Since the cross bar that was put between your latch boxes is twisted, step 1 is to remove it.
Since welds have been painted it is not possible to judge the penetration of the welds.

Now for what I would do, based purely on the thin stock chosen for the cross bar, I would start over. The plate on the bucket looks ok from what is shown as does the latch box, welds are certainly not pretty, but again that is judgement on looks not penetration.
 
 

Tractor & Equipment Auctions

2014 Volkswagen Jetta Sedan (A50324)
2014 Volkswagen...
2021 Cat D5 LGP Dozer (RIDE AND DRIVE) (A50774)
2021 Cat D5 LGP...
2008 UTILITY REEFER TRAILER (A51222)
2008 UTILITY...
1268 (A50490)
1268 (A50490)
2020 CATERPILLAR 289D3 SKID STEER (A51242)
2020 CATERPILLAR...
2015 FORD F-250 XL SUPER DUTY TRUCK (A51406)
2015 FORD F-250 XL...
 
Top