Thunder chicken
Gold Member
I wonder if I could put a PTO pump on my Tacoma?! Haha!!
Single or double acting dump trailer pump?
- Thread starter James Eric
- Start date
- Views: 28039
LD1
Epic Contributor
Mine is power down. Just how Sure-trac built it.
But if you decide to go to power down on the existing cylinders which have only been used as power up....I'd at least flush out the rod-side of the cylinder before tying it all together.
And get rid of the Galvanized water-pipe fittings for high pressure hydraulics
But if you decide to go to power down on the existing cylinders which have only been used as power up....I'd at least flush out the rod-side of the cylinder before tying it all together.
And get rid of the Galvanized water-pipe fittings for high pressure hydraulics
Industrial Toys
Super Star Member
- Joined
- Feb 25, 2008
- Messages
- 16,742
- Location
- Ontario Canada
- Tractor
- Kubota R510 Wheel Loader + Cab and backhoe, JD 6200 Open Station, Cushman 6150, 4x4, ten foot 56 hp Kubota diesel hydraulic wing mower, Steiner 430 Diesel Max, Kawasaki Diesel Mule, JD 4x2 Electric Gator
More and more it seems I have issues with this single acting hoist to get back down again.
EDIT: It just occurred to me what it probably is. I had a different transmission put in the JD and they didn't use the Low Visc Oil I used to use.
jmc
Elite Member
- Joined
- Jul 21, 2003
- Messages
- 3,103
- Location
- SW Indiana
- Tractor
- Ford 1920 4x4 (traded in on Kubota). Case 480F TLB w/4 in 1 bucket, 4x4. Gehl CTL60 tracked loader, Kubota L4330 GST
My Ez-Dumper trailer is power both ways.
What controls the down speed on a one-way?
What controls the down speed on a one-way?
Industrial Toys
Super Star Member
- Joined
- Feb 25, 2008
- Messages
- 16,742
- Location
- Ontario Canada
- Tractor
- Kubota R510 Wheel Loader + Cab and backhoe, JD 6200 Open Station, Cushman 6150, 4x4, ten foot 56 hp Kubota diesel hydraulic wing mower, Steiner 430 Diesel Max, Kawasaki Diesel Mule, JD 4x2 Electric Gator
Feathering the manual valve.
4570Man
Super Star Member
- Joined
- Apr 7, 2015
- Messages
- 18,440
- Location
- Crossville, TN
- Tractor
- Kubota M59, Kubota L3800, Grasshopper 428D, Topkick dump truck, 3500 dump truck, 10 ton trailer, more lighter trailers.
They go down fast which is one of the main advantages IMO. You’re limited by how fast the fluid can exit the cylinder so it’s not like free falling or anything. On my manual valve truck you can somewhat control it. On an electric valve dump trailer you probably only had one speed.
Industrial Toys
Super Star Member
- Joined
- Feb 25, 2008
- Messages
- 16,742
- Location
- Ontario Canada
- Tractor
- Kubota R510 Wheel Loader + Cab and backhoe, JD 6200 Open Station, Cushman 6150, 4x4, ten foot 56 hp Kubota diesel hydraulic wing mower, Steiner 430 Diesel Max, Kawasaki Diesel Mule, JD 4x2 Electric Gator
My smaller highway-use dump trailer has a valve you can feather. In the up position, the pump comes on. No remote. Yes, that wouldn't give any control over speed.
OP
James Eric
Silver Member
- Joined
- Dec 28, 2009
- Messages
- 103
Thanks to everyone for your suggestions. Just so you know, the trailer was free so I plan to replace the pump and motor unit completely so yes all new lines and fluid. Thanks again.
BertZegers
Gold Member
- Joined
- Jan 2, 2012
- Messages
- 259
- Location
- South-West Ontario
- Tractor
- Kubota L2900, Zetor 8011, Kubota KX41Excavator, John Deere 4400 Combine, Case 1816C skidsteer
I had trouble with my single acting cylinder trailer going down. It was the pivots getting seized. After cleaning and greasing all is good again.
