Anyone have any info on this???

[Sparky34]

I picked this up cheap but I've never herd of this manufacturer. It's made by the Raider Mill City Loader Corp. It has a 3 cylinder Kubota diesel in it. I have all the parts for it including the bucket and roll over protection. It looks like the old Case skid steers do. Any info is appreciated.


http://www.tractorbynet.com/forums/attachment.php?attachmentid=342282&d=1382303827&thumb=1&stc=1

 

[ezsparky]

ya have seen and have some more pics of if you like

 

[Napper2]

I just bought a working model of the Raider. They were made in MN in the 80's. Do a google search and someone by the name of Josh has created a website. The 3 cyl Kubota is not an original engine.

 

[small engine guy]

I bought one in 2010 and is a 2142 model. good working condition and use it all the time. If you need operator manual or parts manual I have info on how to get one. They did put a 2 or 3 cyclinder yanmar on these machines. you could call me at 660-826-4788 if you like.

 

[tgmc2500]

I have an old Waldon. Same unit only badged for Waldon forklift co. It has a 3 cyl Yanmar. Runs great.

 

[Looking4new]

I bought one in 2010 and is a 2142 model. good working condition and use it all the time. If you need operator manual or parts manual I have info on how to get one. They did put a 2 or 3 cyclinder yanmar on these machines. you could call me at 660-826-4788 if you like.

Did you know that you could send a Private Message to the OP and give him your phone number rather than posting it on an open forum?

 

[RitchElbe]

saw something like this near the county for Wilkes and Caldwell counties going into Lenoir NC the other day

 

[tgmc2500]

i actually have the original manual for the machine and i bought an engine manual about 15 years ago.

 

[GreenLightning]

Any idea where to get parts for these? I had a couple bearings go out on the rear axles and need to find some salvageable housings and shafts or have mine reworked which I really don't want to do.

 

[tgmc2500]

Any idea where to get parts for these? I had a couple bearings go out on the rear axles and need to find some salvageable housings and shafts or have mine reworked which I really don't want to do.

I have had to have parts made at a machine shop. The bearings in mine are Timken models. Not sure the model # though.