Guess this tool ...

[blueriver]

I would guess that is a pliers taken form the UFO that crashed in Roswell, NM back in the '50's and it is now just being exposed....am I right ?

If the UFO engine was run by a sewing machine motor!!!

 

[blueriver]

Give credit where credit is due...At least two others have correctly identified the tool..

>>>they're used to fix the half-round drive belt of a small engine, like those of an antique sewing machine.<<<

Your right I sent a PM to the kid forgot to send one to Tom ... for the two of them getting it right.

You too get credit ...

 

[blueriver]

Nipple piercing tool?

Something round goes in the hole, then the little punch pierces it.
Dave.

Dave ... thats just wrong!! Rent any pigs yet???

 

[blueriver]

tool for setting demo charges?
punch hole in det cord, crimp blasting caps, etc?

Are you sure you are not under the watchfull eye of the FBI ...

 

[blueriver]

These are clearly Duduk pliers used to adjust and trim thirsimforth inflators.

yep ... clearly you always have to adjust and trim thirsimforth inflators !!!!

 

[tallyho8]

Here is a similar one.

1~V & Round Leather Treadle Belt Belting Tool Plier For Sale

I hate to get off topic, but regarding your link to iOffer, my computer freezes up almost everytime I go to iOffer. Does this happen to any of you?

 

[dave1949]

Dave ... thats just wrong!! Rent any pigs yet???

That was a lot of fun, Thanks BlueRiver. I am going to add Lonesome Dove to my netflix queue tonight.
Dave.

 

[tommu56]

I hate to get off topic, but regarding your link to iOffer, my computer freezes up almost everytime I go to iOffer. Does this happen to any of you?

It locked up mine too fire fox 3.5.5 window XP home?

that was fun Ill rummage through my tool box for some odd tools and post.

Ironically I use to use them for belts on our machines when I worked at a fab shop in the 70's

tom

 

[J_J]

I use EX-8 ,XP. No problems

 

[Erik_in_Hoyt]

Are you sure you are not under the watchfull eye of the FBI ...

I could tell ya, but then I'd haveta...