Have a ZD326, 445 Hours. Noticed that the fuel gauge was not working. Temp gauge not working either. Pulled the Left Tank fuel sensor, no corrosion or obvious problems. Float seemed sound...

I was cutting grass when it suddenly killed. It starts fine but if I move either handle to make it go it kills in a couple of seconds. It only runs with the handles fully extended apart. Another...

My ZD326 was laid up for a couple of weeks while I repaired the fuel gauge and with the hot weather and lots of rain we have been having my grass grew rapidly and was a lot higher and thicker than...

My main gas gauge on my ZD326 stopped working and stays all the way down on empty. I suppose the float in the tank is at fault. How hard is this to repair or replace?

I'm not paying $250 for a Kubota battery. Who knows of a good replacement battery that will fit in a zd326. My original battery is 9"Length, 4 5/8" Wide and 8 3/4" High. 475 CCA.

Ordered three gator blades for my 60” ZD326. I wanted these blades for mulching leafs with my vacuum. Blades are exactly the same size,width as original Kubota blades, except thickness is less. I...

I have a Kubota zd326. One day the wife went to mow, it would not start. I was kind of busy so I just crossed the starter and got it going. A couple hours later after she was done it wouldn't...

I have had to winch my ZD326 out of the mud a few times. Is there anything I can/should do to make it safer and/or easier? My old lawn tractors had a lever to release the hydrostatic transmission...

What's the differences other than cost? The reason I ask is I have a zg327 and going to upgrade to one of these this spring. Looking for suggestions, thanks!

ZD326P Issues began when the mower wouldn't shut off. Used the manual fuel shut off to stop the mower. Went to mow a few days later and the instrument panel was working (guages) and the fuel pump...

I recently added a Grammer MSG75 Low Profile air suspension seat to my ZD326 zero turn mower. I did a blog and added some photos showing the process. Quest for a better Zero Turn Kubota...

I need to get some mulching blades for my 60" ZD326. Where's the best place to get them? Thanks!

Anyone heard of someone swapping out the rear discharge deck on the ZD 326 for a normal side discharge? My love fest for my rear discharge is over. I can't handle live oak leaves not being...

Did the factory lights option for a ZD326 come with a light switch? I don't see one listed in the parts diagram. I'm adding some lights to our mower and don't see a good place to put a switch...

Help lol, 400 HR service removed transmission plug and both rear axle gear case plugs. Drain oil. Changed both filters. Replaced plugs. Manual says to pour fluid slowly. Manuals says 18.8 qrts...

I am planning on purchasing a 2013 Kubota ZD326 zero turn diesel mower next week. Please let me know any negative or positive experiences or issues I should be made aware of on this model. It is...

Howdy ya'll Thought you may like my video of the ZD326 front jack feature. Sure makes accessing the mower deck easy! Really sturdy too. Just let me know if you have any questions...

Like the thread title states: My ZD runs fine off the left tank but not the right. I can literally turn the engine on and off simply by switching from one tank to the other. And I just filled...

My old JD LT-133 finally crapped the bed after +17 years of mostly faithful service. Had no choice but to move to replace it on an accelerated timeline (I planned to do it this fall when a lot of...

I bought a new ZD326 60" with a mulching kit. Naturally, you have to mow a little slower with a mulching kit since the grass is getting mulched under the mower instead of just being thrown out...

The property I mow with these is mostly level 4 acres of rental property with multiple structures and some open field areas. I've used the F2680e for 6 years and the ZD326 for 2 1/2 hours. Will...

Has anybody installed Carlisle AT101s on a Kubota ZD326 or equivalent? The AT101s have a great reputation and I would have done it already but they are technically the wrong size at 24x12-12...

I asked about this last summer and will post this as a follow up post. We went from a Cub Cadet ZTR with lugged tires to a ZD326 with turf tires and were greatly disappointed in how well it got...

Thought you all may enjoy my walk around vid of the Kubota ZD326. If you have any questions about the machine feel free to ask. https://youtu.be/DOYVLzbxeEg

I'll be due for a change in UDT fluid this year, probably towards eoy. This system it appears has two filters on the same system? HST filter and the hydraulic filter. Anyone know why there are...

Hello, I have a Kubota ZD326, and its deck will not raise. It was completely fine the last time I used it, I started it about a month ago because of the deep freeze, took it outside and drove it...

Yesterday I learned that Kubota is introducing the B2601 in 2015. Looks like a nice tractor with new improved ergos. I'm considering trading in my ZD326 for one. My ZD326 is a 2014 model...

Our ZD326 with 60" deck needs new blades and I'm leaning towards a set of Gator G6 blades but am open to suggestions if there's something better. Don't really need aggressive mulching but...

Looking to find out what new ZD366 60 inch side discharge mowers are going for

is there a remote chance anyone can scan the page out of their manual and post it on how to level the deck on a 326? i have spent hours trying to adjust the thing and cant get a straight cut. i...

Other than constantly watching the tube, how do you know to empty before it gets clogged?

Have seen this issue described in the past but never with a final solution. Need to know how to fix this problem. Called the Kubota dealer and they said they never heard of such a thing. ZD 326...

Case in point; 5yr old zero turn ZD326(26hp diesel). I'm having cold starting issues. Starter bendix will click but starter will not engage unless I try starting multiple times. I've tried two...

Hello, Saw on Kubota website that a new 2014 ZD326 is coming out. Anyone have any details on this new machine? I'm in the market for a ZD326 in the next few months. Thanks!

Considering trying a Kubota ZD326 or ZD331 with 60" rear discharge deck and was wondering if the cut grass gets under the ZD326 or ZD331. Do you Z owners have issues with cut grass packing under...

I just picked up a mint condition 2010 ZD326 60" side discharge with 122 hours. I mowed today after about 2 weeks off (was on vacation!) and cut 2-2.5" off of 5" tall grass. The mower handled...

About a year ago i was mowing at little to fast and hit a small stump back on my trails, when I hit it the motor flexed in the mounts and caused somethig to hit the radiator twords the bottom and...

I have a ZD326 and the deck will raise up so you can adjust the height of the cut I want but will only go part of the way back down. No arms seen to be bent so the only thing I can think of is...

I just added led lights to my L5240 and it was a piece of cake. My 5240 had a harness behind the seat to tie in to. I'm about to add led's to my ZD326 and was wondering if it has a harness as...

I致e had this ZD326 for a couple of years, and when I bought it, I thought what a silly arrangement they have on their fuel gauges. There are two separate tanks, left and right. A switch below...

I posted this in the lawn and garden but only received 2 responses so I'm trying here. I probably should have posted here first since it is about buying. I'm looking to buy a Z this month because...

Good morning, I have a Kubota ZD326 mower, with 60" deck. I mow about five acres of grass/weeds. The machine works great for my needs and has good fuel usage. I try to do my own service , oil...

Hi, Does anyone out there have a zd 326 or 331 with say over 1500 hrs on it. I would like to know if they are holding up well especially the ones with the 60 inch dedicated mulching deck. cheers.

Has anyone explored options for more rear tire traction? Turf-savers are ok, but sometimes sure lack decent traction. I suppose the heavy weight of the machine doesn't help either. I remember...

Can the inner air filter be washed? It looks as if it's made from synthetic media which should tolerate a mild cleaning with soap and water.

What would cause a rear main oil seal to all of a sudden start to leak on a ZD326 with 400hrs? It has been about 60hrs since the last oil change and I make frequent checks on all fluid levels...

I saw a Kubota 326 that had bolt on rear splash sheilds,they were on a new Kubota,they were bolted under each fuel tank and extend out, has anyone seen these. I'm guessing they prevent mud from...

After about a year of thinking and procrastinating the new ZTR is finally on it's way. The dealer got it in yesterday and is servicing it today and will deliver tomorrow. We've finally gotten a...

I am thinking of putting the 326 for sale and going back to a tractor. Any thoughts on the value appreciated. 2007 with 212 hrs. Great shape

I purchased a new ZD326 a couple of weeks ago and unfortunately my deck was not level from the dealer. It was about 1/2" higher on one side than the other. I check the level on a very flat and...

Does anyone know if you could use ATV tires on a zero turn mower for increased traction? My ZD326 is terrible with the stock turf tires on it. They are 26x12-12 and I've found some ATV tires...

I had purchased a B2920 with a 60" MMM but I held off a little bit unsure about my real needs. Dealer has been very understanding and has not pressured me at all with anything. They have even...

Hi all, I made my decision - It will be a NEW Kubota ZD326 w/ 60" deck Now it's down to getting the best price I can Wondering what others have paid or been quoted for this wonderful machine

The manual says either one. I have UDT for tractors etc, but not SUDT which I know is more expensive. Does either work ok, or is this hst happier with SUDT? What is everyone else using?

I have a Kubota ZD 326, and I have a problem that I hope someone can help with. My engine, after running awhile will overheat, the temperature guage moves into the red zone, and then emits a high...

Finally the new Kubota I ordered has arrived at my local dealer. I can't wait to get it, even thou theres 2ft of snow still out on the yard, its still exciting! I traded this up from my '98 kubota...

Anyone had the displeasure of changing the tranny oil yet? After about 2 hrs and 2.5 gals later, I finally got it! It takes time for the oil to fill all those small passages in the HST. What a pain!

Received this responce from Customer Satisfaction@Kubota.com Dear Sir: The differences you mentioned below are the only ones between the two models. The engines are the same and the...

I have been looking at the new Kubota 326 pro with the 26hp diesel engine with 60 inch cut and the Ferris 4500 model with the 28Hp cat.diesel 61 inch cut.I have been told by the sales people to...

just wanted to post some pics of my new zd326 Yahoo! Photos - workinallthetime's Photos - kubota bx23 2005 model this thing seems to be a monster yet it is much more quiet than my bx23. the...

11,400 here in tulsa for the zd326 w/ 60" deck i was told no 0% for more than 12 months and no rebates w/ 0% that thing looks like a monster !!!!! ohh and i was also quoted 12,500 for the ferris...