YM186D front dozer blade mounting

[chicora1hillbilly]

I bought this older tractor with low hours on and was pleased with the results. This little tractor is an awesome work horse.
The front blade pusher assembly has a mounting point at back that is also used to brace the three point hitch. I am missing what attaches these points to the tractor. It appears that I may be missing short bolts that are approx. 3/4 inch in dia. except metric of course. Could someone advise me of what I am missing and the size if possible.
Thanks Paul the Chicora Hillbilly

 

[winston1]

I'm not sure just what you need but if you look toward the end of this parts pdf you will see a listing of the bolts related to the 3 point. I believe there sizes are shown. One of our members has a considerable amount of information on the ym186. You might try to pm him and ask. His user name is rScotty. http://downloads.pfgaustralia.com.au/intranetwebcache/Parts/PARTS LISTINGS/Yanmar/YM186D.pdf

 

[chicora1hillbilly]

Thanks winston1, however I cannot get the link to load. Perhaps another member will know what I am in need of.

 

[jerrybob]

Check out Hoye tractor in Texas.......

Yanmar Tractor Parts: THREEPOINT

 

[ym165dpete]

I have a ym165d with a yanmar dozer blade .The booklet that came with it shows the under frame is bolted to the tractor rear axle six bolts 3 on each side,they are M10x 1.50x70 bolts and six 7/16 lockwashers this may be different on your ym186D Pete

 

[chicora1hillbilly]

Thank you for the link. What I am missing attaches the bar where the lower lift arms attach to the tractor.

 

[chicora1hillbilly]

Thank you for the info. Mine attaches at the rear with just one bolt? on each side.

 

[chicora1hillbilly]

Many thanks to Gary at Jamieson Tractor for the info and drawings. I need 2 bolts listed as M22x50 with 1.5 thread, perhaps longer to go thru both mountings and into the tractor