Joystick control on my XR4150 was sticking when I raised the loader up. If I forgot to return it, it would continue to rise. I took the covers off and greased the plungers as good as I could, hoping that would work. Now, it is sticking in both the up and down directions. It seems that I made it worse. Tilt and curl return to center immediately when the lever is released. This is a cable connection to the actual valve. Any suggestions?
XR4150 Loader Joystick Sticking
- Thread starter KP2654
- Start date
- Views: 716
Harry in Ky
Veteran Member
You probably need a new cable.
mred2
Platinum Member
- Joined
- Aug 31, 2018
- Messages
- 888
- Location
- West Alabama, USA
- Tractor
- iseki tl3200, JD 450H dozer, LS XR4150, Genie Z34/22N lift
I had to lube mine and use it. It went back to ok about a week later.
