HP942
Silver Member
Anyone put wheel spacers on their XJ? If so where did you get them?
XJ2025H Wheel spacers
- Thread starter HP942
- Start date
- Views: 3299
I put 2 inch spacers on off of EBay for 100$ or so. Then I had to buy some hardware. Worked out well enough for a bit more piece of mind. Here is a link to the seller, though they only show the 1 1/2" spacers. 2pc 1.5 inch | Skid Steer Wheel Spacers - 6 Lug Bobcat Case John Deere CAT Terex | eBay
kormidoit
Bronze Member
- Joined
- Feb 16, 2021
- Messages
- 93
- Location
- Lake Almanor, CA.
- Tractor
- 2021 LS MT225S, 2003 Kubota BX2200
I purchased Bora 2" rear wheel spacers for my MT225S. So far so good....www.motorsport-tech.com
Texasmark
Elite Member
- Joined
- Apr 24, 2012
- Messages
- 3,766
- Location
- N. Texas
- Tractor
- Ford: '88 3910 Series II, '80 3600, '65 3000; '07 6530C Branson with FEL, 2020 LS MT225S. Case-IH 395 and 895 with cab. All Diesels
Not for an XJ but the principle is the same:
I made my 4". I originally made them for my Branson2400 but upon selling it I kept them. When I bought the MT225s they fit perfectly.
Used 2 pieces of 1/4" steel plate per side (4 total). I used the wheel for a pattern. Took them to a machine shop and had them made. I forget the cost but not all that much and I wanted a set of 4" spacers and couldn't find any www sellers of 4". I then took a couple of pieces of 8" diameter steel pipe 3 1/2" long to make the pair. A little welding, a little paint and presto.
I made my 4". I originally made them for my Branson2400 but upon selling it I kept them. When I bought the MT225s they fit perfectly.
Used 2 pieces of 1/4" steel plate per side (4 total). I used the wheel for a pattern. Took them to a machine shop and had them made. I forget the cost but not all that much and I wanted a set of 4" spacers and couldn't find any www sellers of 4". I then took a couple of pieces of 8" diameter steel pipe 3 1/2" long to make the pair. A little welding, a little paint and presto.
Attachments
Last edited:
