Wire Welder Question

[rcowan]

Sounds like another great use for WD40. :thumbsup:
Now if you could use Duct Tape to hold the door closed on the welder it would be a complete kit.

RC

Okay .... I have to confess that I once tried WD40 when I was struggling with feed issues (before tip change)

It made a very noticeable improvement.

I was careful to do quite a bit of non-critical welding until I felt that most of the WD40 was gone.

Sherweld

 

[motzy77]

I needed a quick repair and the only wire I had left at the time had some light rust spots. Big mistake, now I apparently have some of this on the inside of my cable liner, because I'm getting uneven feed on the wire. Any recommendations on cleaning the liner, or am I out the cost of a new liner.

Its the Tip...your welcome..