Will this spool work

[woodlandfarms]

I am designing a 3pt hitch for my tractor. I was given 2 double acting clinders and still am not sure this is the direction I want to go.... That said,,,

lets say each cylinder is going to act as an arm lift. This would allow me some tilt control I beleive. But I want both cylinders to float Would this spool valve float both cylinders? I know little about this clearly...


Surplus Center - 2 SPOOL 8 GPM PRINCE MB21GB5C1 DA VALVE W/FLOAT

 

[bcp]

Sounds like only one has float:

"Spool Details:
Spool 1 DA cylinder spool, spring to center with detent float
Spool 2 DA cylinder spool, spring to center"

 

[bcp]

Maybe you could use one cylinder for lift and one for tilt.

Bruce

 

[J_J]

Carl,

What ever you connect to the float spool will float.

Two cyl connected to the float valve will float two cyl .

If you need float on the other spool circuit, then use this valve.

Surplus Center - 20 GPM 1/2" NPT FLOAT VALVE PRINCE SS-2B1D

If you built up a stack valve, you could have float on each spool.

Surplus Center - 2 SPOOL SV VALVE OPEN CENTER

Two of these - SVW1DD1