Welding oil field pipe and sucker rods

   / Welding oil field pipe and sucker rods #1  

Deere5420

New member
Joined
Jun 20, 2016
Messages
11
Location
SW MO
Tractor
J.D. 5420
I have a Hobart 210 mig welder with a generator. I am building a perimeter fence and using oil field pipe and sucker rods on the corners. If I use flux core wire (.35), do you think this will work without it breaking continuously? Don't really want to break down and buy a gas powered stick welder. Thanks.
 
   / Welding oil field pipe and sucker rods #2  
As long as generator has capacity to handle the initial surge loads when you first strike arc there should be no problems.... HOBART recommends a generator with about 50% more watt ratings the what welder actually draws..... This keeps generator from bogging down every time you strike arc....
 
   / Welding oil field pipe and sucker rods #3  
What oil field pipe are you using? 2 and 7/8th pipe and sucker rod sure can be magnetized but maybe you know that.
 

Tractor & Equipment Auctions

2014 FORD F250 XL SUPER DUTY CREW CAB TRUCK (A51406)
2014 FORD F250 XL...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
LOAD OUT INFORMATION LOT NUMBER 4 (A53084)
LOAD OUT...
NEW 23hp Land Hero Stand Up Skid Steer (A53002)
NEW 23hp Land Hero...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
Crosley 10ft Hydraulic T/A Dump Trailer (A50322)
Crosley 10ft...
 
Top