Warranty Question!

/ Warranty Question! #1  

GreenLaw

Member
Joined
May 16, 2006
Messages
25
Location
Bowling Green, Kentucky
I received my Kubota Grand L3130 with FEL less than two weeks ago. I noticed afew days ago, that I have a hydrolic leak around one of the FEL fittings. My question is this: Is the leak covered by the warranty? or How hard is it to fix it myself? I have never messed around with the hydrolic system. It doesn't look that hard, could I just unscrew the fitting and try placing some tape around the threads? Thanks for your attention. James
 
/ Warranty Question! #2  
Probably all you need to do is tighten the fittings. My B7800 had a few leaks develop after the first couple of hours. A little bit of oil is all it takes to make a big mess.
 
/ Warranty Question! #3  
Most don't recommend the tape but mine was assembled with plenty. I wouldn't be too concerned on contaminating the hydraulic fluid but I'd use it sparingly. It do stop leaks. Simply tightening is usually enough though.
 
/ Warranty Question! #4  
I had the same thing happen. My dealership is quite local so I took the tractor back and the leaks were stopped right then..... no charge. It must be normal at first for to have a few leaks. I would be careful not to over tighten them or twist a line. I have had no more leaks in over 50 hrs.

Good luck!
 
/ Warranty Question! #5  
The BH on my 3130 had a couple leaky fittings. I tightened them a little and no more leaks. It should be covered by warranty but if you can turn a wrench, it would be alot easier just to much sure the fittings are tight before going to the trouble of taking it in to the dealer or having them make a house call. Dont torque on them too hard, snug and 1/4 turn should do it.
 
/ Warranty Question!
  • Thread Starter
#6  
Thanks everybody for providing me with alittle help. I have to work tomorrow, but I will try to carefully tighten the fitting. I hope that will take care of it. It hasn't leaked abunch, but it really conserns me. Thanks again. James
 
/ Warranty Question! #7  
If you do remove any hoses or fittings,make sure the pressure is relived by having your bucket on the ground. Noboby wants to take a hydraulic oil bath or be injured by a falling loader. Norton
 

Marketplace Items

20ft 2-Door Shipping Container (A61572)
20ft 2-Door...
2014 Chevrolet Sonic Sedan (A61574)
2014 Chevrolet...
KELDERMAN KRC 111D HAY RAKE (A64280)
KELDERMAN KRC 111D...
Kubota Snow plow with subframe
Kubota Snow plow...
2022 Schulte SMR-800 Multi Rake Landscape Windrower (A63688)
2022 Schulte...
3pt 4' Dirt Scoop (A64119)
3pt 4' Dirt Scoop...
 
Top