Waldon 5000

[butcherpl]

I own a loader, waldon 5000. I have to change the starter and i ran into a problem. After removing 3 nuts form the starter mount, I can't wiggle the starter out form the bay. First time doing this job. On my way I have the oil filter nest and the dipstick. should I remove them first before trying to take out the starter? any help is appreciated! Thanks!

 

[mitch becton]

first welcome to the forums what i can find on this is it has a perkins motor any way you can post picture or pictures of the starter did one recently on very large wood chipper the replacement was about 1 inch longer customer tried for 2 days to install so i went to his place and all i had to do was remove dipstick tube and bolt it up but had to be in a straight line to housing to install or remove good luck

 

[butcherpl]

first welcome to the forums what i can find on this is it has a perkins motor any way you can post picture or pictures of the starter did one recently on very large wood chipper the replacement was about 1 inch longer customer tried for 2 days to install so i went to his place and all i had to do was remove dipstick tube and bolt it up but had to be in a straight line to housing to install or remove good luck

Thanks Mitch for the respond. I will try to do that first, I would post pictures, but currently the loader is out of state. will have some next week when i get there and try this job again!