Vaalkameel
- Thread starter smitan
- Start date
- Views: 1433
deerseeker001
Super Member
- Joined
- Jul 20, 2011
- Messages
- 5,734
- Location
- Central wisconsin
- Tractor
- International 2500a with Loader
Welcome from Wisconsin
TractorTech
Elite Member
- Joined
- Jan 26, 2012
- Messages
- 3,056
- Location
- California
- Tractor
- Ford 7710, Ford 550, Ford 1910, Ford 4430, KD Forklift, Ford LGT17H, New Holland L255 Skidsteer
Did you try Ebay or Same tractor: Request technical assistance ?
Briana03
Elite Member
Welcome to TractorByNet!
:welcome:
:welcome:
Walkin Horse
Platinum Member
- Joined
- Sep 6, 2011
- Messages
- 695
- Location
- Chesterfield Va
- Tractor
- Shibuara Ford New Holland 555D NH Workmaster 55
Welcome from Va
shanehobson
Silver Member
- Joined
- Jul 25, 2011
- Messages
- 112
- Location
- New Zealand
- Tractor
- Ford 3000 (x2), Kubota F1900, Kubota B2150HST, IH434, Same Minitauro 60, Zetor 6745 (x2)
I have a workshop manual and ops manual if you're still looking.
TBN Support
TBN Support
- Joined
- Feb 4, 2015
- Messages
- 4,560
Welcome to the forum.
It looks like you might have found your answer.
I'm going to move this thread on over to the projects section. Best of luck!
It looks like you might have found your answer.
I'm going to move this thread on over to the projects section. Best of luck!
Jakkels
New member
Good day. We just bought a SAME Minitauro 60.We bought it as a Falcon 50, but after checking the engine no and bore we realised its a Mintauro 60. We (my son 19, the farmer and I, an aircraft mechanic) bought it with the engine partially disassembled. We realised some of the piston rings were stuck due to being fitted upside down. After a whole day of cleaning honing and burs removal we assembled it and it runs good. When hot the oil light flashes at idle so the oil pressure is a bit low. Looks like we have to fit new big end and main bearings.
We do have a lot of questions, like why are there 2 levers fort 3 point lift? Lift and draft control below the steering and left of the seat a second spring loaded lever that also raise the lift?
If any one can help with a operators and workshop manual, it would be great!
We do have a lot of questions, like why are there 2 levers fort 3 point lift? Lift and draft control below the steering and left of the seat a second spring loaded lever that also raise the lift?
If any one can help with a operators and workshop manual, it would be great!
Wagtail
Super Star Member
- Joined
- Jan 15, 2013
- Messages
- 12,962
- Location
- St Helens, Tasmania, Australia
- Tractor
- JD 4105 / JD Z355E (48" deck)
G'day Mate and welcome to TBN from Downunder.
Enjoy the site... from wherever in the world you are.
Some pictures of the levers will go a long way in helping us help you and your son.
Enjoy the site... from wherever in the world you are.
Some pictures of the levers will go a long way in helping us help you and your son.
