Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,842
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
Dimple Dies
Using a shop press - tips & tricks
- Thread starter BigBlue1
- Start date
- Views: 10742
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,842
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
The ram's receiver.
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,842
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
A laminated wood block I keep handy.
Use your imagination as to its uses. I'm certain you will have plenty.
Use your imagination as to its uses. I'm certain you will have plenty.
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,842
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
Some dies. All shop made as needed.
Pipe dies from a store bought (Harbor Freight type) hydraulic bending kit modified to fit Big Barn receiver.
Pipe dies from a store bought (Harbor Freight type) hydraulic bending kit modified to fit Big Barn receiver.
Last edited:
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,842
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
Lift assembly for bed height adjustment...
jonsstihl
Veteran Member
subscribed, neat to see all these ideas. the possiblities are endless. I just need to start out by getting one or building one.
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,842
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
No bolts used for height adjustment.
4 inch increments achieved utilizing 1x4x14" flat bar.
4 inch increments achieved utilizing 1x4x14" flat bar.
Last edited:
cqaigy2
Super Member
Nice!
