I'm in the process of building a front end loader for my cub cadet. Got the plans from P.F. Engineering. Their plans call for hoses all down the boom for the cylinders, but I would like to use a tubing along the boom and branch off with the hoses for the cylinders. Does anyone know what type tubing I should use and a good place to purchase it. Thankful for any info. Jeff.
tubing for front end loader
- Thread starter jholland
- Start date
- Views: 3145
/pine
Super Star Member
- Joined
- Mar 4, 2009
- Messages
- 12,450
Most hydraulic supply houses carry it...if you don't want to paint it you'll need stainless...
wdchyd
Elite Member
Where are you located?
OP
jholland
New member
- Joined
- Apr 23, 2011
- Messages
- 7
- Tractor
- cub cadet 86,cub cadet 109,ccc/mtd 580
I'm in Stanley, North Carolina. Another question, my hydraulic hoses are 3/8 npt with an inside dia of 0.274. Should my tubing have basically the same inside dia? And should the outside dia be the same as my hoses. And also what about wall thickness. Just want to be sure and get the right stuff. Thanks, Jeff.
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 12,897
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
I am guessing that you don't have the special tools to bend and flare hydraulic tubing and crimp connectors to hoses.
My loader came with the tubing, so when I finished the put-together, I took it to a hydraulic shop and they made the hoses that hook to the tubing.
I recommend that you make some type of quick connect system for the attachments. Look at my thread and you will see why I wish that I had done it before I made my pin on attachments. http://www.tractorbynet.com/forums/customization/272163-fel-toro-groundsmaster-put-together.html
