Actually had a TS 1610 Iseki gave to me. Only 125 hrs. I know its hard to believe. Here is the catch. rear hyds. with only lift a 4ft box about 2-3 inches. My bet is a blown seal? Anyone have any input on problem/cost to repair? SHe lifts up without anything on and does not make any noices. It just won't hold anything up. Thank, Jeff.
TS 1610 Hyd. Problem. I think!
- Thread starter jheat5
- Start date
- Views: 1284
buppy69
Platinum Member
Have you checked the fluid level?
Eugene
Eugene
kayssupply
Platinum Member
I had a Hinomoto that sheared the key in the pump shaft. It was a simple fix.
I've shecked the fluids and all are fine. It will lift fine with "no" weight on the arms. Then after you mount an implement, it will lift to some degree, contingent on the weight of the implement. It will not however, hold the tool up. It "leaks" by and lowers it to the ground.
Here are some similar links:
